Choosing A Power Supply; Using Batteries - Sangean ATS-808A User Manual

CHOOSING A POWER SUPPLY

You can operate the receiver using:
Six Alkaline AA Batteries.
Household AC [With optional AC adaptor]
12 Volt DC Automobile Battery [With
optional DC adaptor]

USING BATTERIES

1. Press latch marked OPEN on both
battery ompartment covers in he
direction of the arrow and lift off cover.
2
1
NOTE
Whenever the radio is turned off, the battery
indiator will flash for about five seconds to
show battery condition.
If the indicator falls below #2, the 4 "MAIN
AA" batteries should be replaced.
2. Insert 4 AA batteries in the Radio
compartment and 2 AA batteries in
the Back-up compartment. Be sure
to position them as illustrated on the
back of the radio, and on top of the lift-out
ribbons for easy removal.
3. Replace both battery compartment
covers over their respective compartments
and press down until you hear it snap closed
When the "MAIN" batteries become ex-
hausted, the micro-processor will automa-
tically be powered bythe "BACK-UP"
batteries.
When the display on the micro-processor
begins to fade, replace the 2 "AA" batteries
in the "BACK -UP" circuit. Before you
replace these batteries, be sure to install the
4 "AA" batteries in the "MAIN" circuit to
prevent total memory loss.
5
4
3
2
1