Airaid 451-328 Installation Instructions

Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.
700-495 Airaid Oiled Media
702-495 Airaid SynthaMax Dry Media - Black
1. Remove the battery box cover in the cowl and discon-
nect the negative battery terminal.
MAF
4. Gently pry the harness anchor out of the airbox and
disconnect the mass air flow meter.
7. Install the Filter Adapter onto the Cold Air Box as
shown, using the three 1/4-20 Button Head Screws and
1/4" Flat Washers
FILTER IDENTIFICATION
2. Remove the strut tower brace is so equipped. Lift up
on the engine cover to unseat it from it's mounting
grommets and set it aside.
Anchor
5. Remove the 6mm airbox mounting bolt in the inner
fender and lift the entire airbox assembly out of the
vehicle. Set the bolt aside for now. It is to be reused.
8. Place the Airaid Airbox assembly into the engine
compartment as shown, with the locator pin on the bot-
tom of the box inside the fender grommet. Secure the
Airbox by reusing the 6mm bolt removed in step # 5.
Bolt
Pin
Installation Instructions
For Part Numbers:
450-328
700-495 Airaid Oiled Media Filter
451-328
701-495 SynthaMax Dry Media Filter - Red
452-328
702-495 SynthaMax Dry Media Filter - Black
453-328
703-495 SynthaMax Dry Media Filter - Blue
2015 Ford Mustang
5.0L GT V8
Component Identification
1 Airaid Premium Filter
2 Cold Air Box
3 Airaid Intake Tube
4 Reducing Coupler
5 Hump Hose
6 Filter Adapter
7 Air Box Lid
8 Air Box Window
9 1" Hose
Hardware and Instructions
10 ¼" Flat Washer
11 ¼"-20 x ½" Button Head Screw
12 Button Head Screw
13 Aluminum Fitting
14 5/8 Aluminum Fitting
15 1/2" Grommet
16 3/16" Grommet
17 Resonator Cap, (Not Shown)
18 #56 Hose Clamp
19 #64 Hose Clamp
20 #68 Hose Clamp
21 Speed Clamp
22 Firewall Plug, (Not Shown)
701-495 Airaid SynthaMax Dry Media - Red
703-495 Airaid SynthaMax Dry Media - Blue
2
3
3. Disconnect the 3 breather lines and resonator tube from
the intake tube. Loosen the hose clamps and remove the
factory intake tube.
6. Be sure the speed clip and the airbox grommet remain
inside the vehicle. They will be reused.
9. Slide the Hump Hose and Clamps onto the Filter
Adapter as shown. Do not tighten the clamps at this time.
1
1
1
1
1
1
1
1
1
1
9
9
2
2
1
2
1
1
1
1
2
2
1
1
Resonator