Airaid 401-762 Installation Instructions

C
B
A
Component Identification
Description
A HOSE CLAMP #48
B HOSE; 3.5" TO 3"ID X 3"L TPRD
C HOSE CLAMP #56
D INTAKE TUBE (MP)
E VENT; 1/4 NPT QUICK
F CABLE TIE; 6", BLACK
G HOSE; HUMP 3.5"ID TO 3.75"
H HOSE CLAMP #60 STAINLESS
I FILTER
Full color instructions can be viewed on our web site at Airaid.com. If you need any assistance please call 1-800-498-6951 to speak with
TO START:
1. Turn off the ignition and disconnect the negative
battery cable.
NOTE: Disconnecting the negative battery cable
erases pre-programmed electronic memories. Write
down all memory settings before disconnecting the
negative battery cable. Some radios will require
an anti-theft code to be entered after the battery is
reconnected. The anti-theft code is typically supplied
with your owner's manual. In the event your vehicles
anti-theft code cannot be recovered, contact an
authorized dealership to obtain your vehicles anti-
theft code.
2. Release the locking tabs and then disconnect the
Crank Case vent lines from the intake tube.
E
D
Qty. Part #
1 08601
1 084055
2 08620
1 KIT762
2 082628
1 1-127
1 08639
1 08628
1 860/861-397
a representative in our Customer Service Center before returning the product.
3. Unclip the harness and hose support from the intake
tube. Loosen the hose clamps that secure the intake tube
to the throttle body and air filter housing then remove
the intake tube from the vehicle.
NOTE: AIRAID recommends that customers do not
discard factory air intake.
5. Release the clips that secure the upper air filter
housing and then remove the upper housing and factory
intake tube.
Installation Instructions
For Part Numbers:
400-762
401-762
2018 FORD F150
V6-3.3L
C
G
H
E
F
I
FACTORY
PART
860-397 Airaid Oiled Media Filter
861-397 SynthaMax Dry Media Filter - Red
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
See Airaid.com for CARB status on each part for a specific vehicle
FACTORY
PART
6. Install the provided coupler (084055) onto the throttle
body and secure with the provided hose clamp.
7. Install the provided hump coupler (08639) onto the air
filter housing and secure with the provided hose clamp.