Airaid 402-368 Installation Instructions

B
A
C
Component Identification
Description
A HOSE CLAMP #56
B HOSE; 3-1/2" ID X 2"L REIN.
C INTAKE TUBE
D SUPER GLUE, 3G DRIP PROOF
E HOSE; 3-1/2"ID X 2-1/2" L HUMP
Full color instructions can be viewed on our web site at Airaid.com. If you need any assistance please call 1-800-498-6951 to speak with
TO START:
1. Turn off the ignition and disconnect the negative
battery cable.
NOTE: Disconnecting the negative battery cable
erases pre-programmed electronic memories. Write
down all memory settings before disconnecting the
negative battery cable. Some radios will require
an anti-theft code to be entered after the battery is
reconnected. The anti-theft code is typically supplied
with your owner's manual. In the event your vehicles
anti-theft code cannot be recovered, contact an
authorized dealership to obtain your vehicles anti-
theft code.
2. Disconnect the EVAP vent connection and crank case
vent connection.
A
A
D
I
Qty. Part # Description
4 08620 F BOLT; M6 X 1.00 X 16MM, SS
1 08698 G WASHER; M6 SPLIT LOCK ZINC
1 KIT27398TK H WASHER; 6MM , FLAT , SS
1 409 I EDGE TRIM (19")
1 08699 J EDGE TRIM (39")
a representative in our Customer Service Center before returning the product.
3. Loosen the hose clamps at the throttle body and filter
inlet that secure the factory intake tube.
4. Unhook the coolant line from the intake tube and then
remove the intake tube from the vehicle.
NOTE: AIRAID recommends that customers do not
discard factory air intake.
Installation Instructions
For Part Numbers:
402-368
2015-18 / FORD / F150
V8-5.0L
E
A
G
F
H
G
K
Qty. Part #
2 07730
2 1-3025
2 08269
1 102451
1 102496
702-466 SynthaMax Dry Media Filter - Black
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
See Airaid.com for CARB status on each part for a specific vehicle
J
L
I
Description
K HEAT SHIELD
L ADAPTER; UNIVERSAL, 6"
M HOSE CLAMP #104
N AIR FILTER
5. Release the two clips securing the upper air filter
housing and then remove the upper filter housing and
stock air filter.
6. Install the filter adapter into the AIRAID
and secure with provided hardware.
M
N
Qty. Part #
1 073182
1 21512-1
1 08697
1 702-466
heat shield
®