Mounting On A Table; Using The Kensington Security System - LG 65UL3E Owner's Manual

Mounting on a Table

1 Lift and tilt the monitor into its upright position on a table.
• Leave a 10 cm (minimum) space from the wall for proper
ventilation.
(Depending on model)
2 Connect the power cord to a wall outlet.
• Do not apply foreign substances (oils, lubricants, etc.) to the
screw parts when assembling the product.
(Doing so may damage the product.)
• If you install the monitor on a stand, you need to take actions
to prevent the product from overturning. Otherwise, the
product may fall over, which may cause injury.
• Do not use any unapproved items to ensure the safety and
product life span.
• Any damage or injuries caused by using unapproved items
are not covered by the manufacturer's warranty.
• Make sure that the screws are inserted correctly and fastened
securely. (If they are not fastened securely enough, the
monitor may tilt forward after being installed.) Do not use
too much force and over tighten the screws; otherwise screw
may be damaged and not tighten correctly.
6
10 cm
Using the Kensington security
system
The Kensington security system connector is located at the rear of the
monitor. For more information of installation and using, refer to the
manual provided with the Kensington security system or visit http://
www.kensington.com. Connect the Kensington security system cable
between the monitor and a table.
(Depending on model)