Installation & Maintenance; Environment; In Case Of Pump-Drained Washer; How To Connect Water Supply Hose - Samsung SW57APP User Manual

ENVIRONMENT

Leave some space.
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise and vibration can occur
(allowable slope is 1 degree)
Never install the washer in a very steamy
environment or where it might be open to the rain.
Excessive moisture may cause an electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected
by direct heat,never place the washer near furnaces,
boilers,etc.Do not place under direct sunlight.

HOW TO CONNECT WATER SUPPLY HOSE

Check the type of tap fitting which is in your laundry and then see appropriate instruction below:
A tap of ordinary type is desirable
ORDINARY TAP SQUARE TAP
1. Remove the adaptor from the
water supply hose.
2. First,using a "+" type screw
driver, loosen the four screws on
the adaptor.
Next,take the adaptor and
turn part(b) following the
arrow for gap about 5mm
between them.
3. Connect adaptor to the water
tap by tightening the screws
firmly.
Then,turn part (b) following
the arrow and put (a) and
(b)together.
Note : The appliance is to be connected to the water mains using new hose-sets and that old hose-sets should not
be used.
SW68ASP-02290A-EN.indd 4
INSTALLATION & MAINTENANCE

IN CASE OF PUMP-DRAINED WASHER

 T ake out the
cap-hose and
connect the
outlet-hose
In case of square tap
 T ake out the internal part of the connector
and join it in the following way.
ROTATING TAP
4
 Be sure to join tightly  Install the drain
the drain hose into the hose in the position
drain-outlet on the left of about 70~80cm
side of the machine. above the ground.
Internal part
4. Connect the water supply hose to
the adaptor. Pull down the part
(c) of the water supply hose .
When you release part (c) the
hose is automatically connects to
the adaptor making a 'click' sound.
5. Connect the other end of the water
supply hose to the inlet water valve
at the top of the washer.
Screw the hose clockwise all the
way in.
6. If the water tap is a screw type,
assemble a water supply hose that
fits to the tap as shown.
2006-08-21 ¿ÀÈÄ 8:33:11