Connect Interface To Controller; Connect Interface To Icc - Hunter IMMS-CI-HW Installation Instructions Manual

CONNECT INTERFACE TO CONTROLLER............................................................................

1. Use approximately 6 ft. (2 m) of 18 AWG (1 mm) 5-conductor
sprinkler wire to connect interface to the controller.
2. Strip wires approximately
color, at the "To Controller" section of the terminal strips.
3. Route wire (in separate conduit from AC power) to the controller.

CONNECT INTERFACE TO ICC ...............................................................................................

With controller power OFF, strip
wire ends approximately 1⁄4" (6 mm)
and connect by color code to
the ICC power module terminals
as shown.
⁄ " (4.5 mm) and attach to interface, by
3
16
POWER
Controller
AC Comm.
From
AC
Transformer
24 VAC
REM
24 VAC
SEN
Ground
SEN
To SmartPort
Sensor 1
Sensor 2
IMMS
™
Sensor 3
Controller
Sensor
Common Interface
SI 1
SI 2
Earth Ground
Drain wires here
SI 3
SI 4
CI 1
CI 2
CI 3
CI 4
POWER
Controller
AC Comm.
From
AC
Transformer
24 VAC
REM
24 VAC
SEN
Ground
SEN
To SmartPort
Sensor 1
Sensor 2
IMMS
™
Sensor 3
Controller
Sensor
Common
Interface
SI 1
SI 2
Earth Ground
SI 3 Drain wires here
SI 4
CI 1
CI 2
CI 3
CI 4
3