Flow-Clik Imms - Hunter IMMS-CI-HW Installation Instructions Manual

FLOW-CLIK IMMS ...................................................................................................................

1. Route the Flow-Clik™ sensor cable through the low-voltage conduit.
Strip and connect the 2 yellow power wires from the sensor receiver
to the power terminals in the interface.
2. Connect one of the white wires to the Sensor number, and the other
to "Sensor Common".
12
POWER
Controller
AC Comm.
From
Transformer AC
24 VAC
REM
24 VAC
SEN
Ground
SEN
To SmartPort
Sensor 1
Sensor 2
IMMS
™
Sensor 3
Controller
Sensor
Common
Interface
SI 1
SI 2
Earth Ground
Drain wires here
SI 3
SI 4
CI 1
CI 2
CI 3
CI 4