Advertisement
Remove about 1" (25 mm) of the jacket from the
1
cable end by scoring and slicing the jacket.
Position the tool on the cable so that the corrugation
guide is about 1/2" (13 mm) from the cable end.
Pull off the cut conductor. Slit and peel the scored
3
section of jacket.
Andrew Corporation
10500 West 153rd Street
Orland Park, IL U.S.A. 60462
The installation, maintenance, and removal of antenna
systems requires qualified, experienced personnel.
Andrew installation instructions are written for such
personnel. Antenna systems should be inspected once
a year by qualified personnel to verify proper
installation, maintenance, and condition of equipment.
Andrew disclaims any liability or responsibility for the
results of improper or unsafe installation practices.
Telephone: 708-349-3300
FAX (U.S.A.): 1-800-349-5444
Internet: http://www.andrew.com
Lightly squeeze the tool halves together and rotate
2
the tool clockwise (as viewed from the cable end)
three or four revolutions to score the outer
conductor. Then, firmly squeeze and rotate the tool until
the cut section falls away. Note: Keep a firm and
constant grip on the tool. Do not release the tool during
rotation because this will result in an uneven cut.
Proceed to the connector installation bulletin.
Notice
Customer Service, 24 hours: U.S.A. • Canada • Mexico: 1-800-255-1479
U.K.: 0800 250055 • Other Europe: +44 1592 782612
Printed in U.S.A.9/00
Copyright © 2000 by Andrew Corporation
Advertisement
