Advertisement
Ardwolf A1 Quick Start Guide
INTRODUCTION
Thank you for choosing the Ardwolf A1 fingerprint keypad lock. No more worries about losing
your keys!
There are three ways to unlock the Ardwolf A1:
(A) Fingerprint – Place finger on sensor
(B) User code – Enter user code number and press #
(C) Key – Insert key and turn clockwise 180
*For increased security, a "Double verification mode" option is available, see user manual for
details.
CHANGE THE PROGRAMMING CODE (PASSWORD)
IMPORTANT NOTES:
⦁
As a precaution, you should change the default Programming Code or password to
insure that no one else can make changes to the door lock settings.
⦁
To verify that you have pressed a button successfully, you should hold down the button
until you hear a beep and see a blue light, then release the button.
⦁
During the setup, there is a 5 second time limit between button presses. If you wait over
5 seconds without pressing a button, the door lock keypad will flash red twice and then
exit the current setup (losing unsaved changes). So make sure to enter button presses
within 5 seconds of each other to complete all steps.
To begin changing Programming Code
(password), press 0 and then * to start login
Enter the default Programming Code (1234) and
then press #.
Choose and enter your new password (which can
be 4-12 digits long) and then press *
1
___ ___ ___ ___
Advertisement
Table of Contents
Related Manuals for Ardwolf A1
Summary of Contents for Ardwolf A1
- Page 1 Ardwolf A1 Quick Start Guide INTRODUCTION Thank you for choosing the Ardwolf A1 fingerprint keypad lock. No more worries about losing your keys! There are three ways to unlock the Ardwolf A1: (A) Fingerprint – Place finger on sensor (B) User code – Enter user code number and press # (C) Key –...
- Page 2 Enter your new password again to verify it and then press #. ___ ___ ___ ___ NOTE: If you hear a long beep and see blue light, the entry is successful! Two short beeps and red light means entry has failed. Repeat if it fails. ADD THE FIRST FINGERPRINT (ADMINISTRATOR) IMPORTANT NOTES: ⦁...
- Page 3 Place your finger on the sensor firmly with medium pressure. Make sure that finger is lying flat on sensor and centered on fingerprint sensor. If you hear a long beep and see blue light, the entry is successful! Two short beeps and red light means entry has failed.
- Page 4 So try to use finger to unlock for 5 or more times after you add your fingerprint in system. After unlocking, the Ardwolf A1 will automatically lock itself again after 5 seconds. ADD MORE FINGERPRINTS / USERS To add more fingerprints/users, just repeat steps for adding fingerprint, but choose a different User ID number than you’ve used before.
- Page 5 ADD USER CODES (UNLOCK WITH NUMBER) IMPORTANT NOTES: ⦁ You can add up to 100 user codes into the door lock. Each user is given a User ID number from 0 to 99 ⦁ If you should enter any mistakes in the middle of setup, you can wait over 5 seconds and system will exit setup and discard the current entry.
- Page 6 If the user code is authenticated, you will hear one long beep and the keypad will show blue light. The lock will unlock. Otherwise, you will hear two short beeps and the keypad will show red light.
- Page 7 KEY UNLOCK Insert a key in the cylinder and rotate 180° CLOCKWISE, then turn lever to unlock. Rotate a key 180° COUNTER CLOCKWISE then take out the key to lock.
Need help?
Do you have a question about the A1 and is the answer not in the manual?
Questions and answers