Probe Maintenance & Cleaning; Accessories - Hanna HI8410 Instruction Manual

For a top performance probe, it is recommended to replace the membrane
every 2 months and the electrolyte once a month.
Proceed as follows:
• Unscrew the membrane by turning it counterclockwise.
• Rinse the supplied spare membrane (HI 76409A/P) with some
• Gently tap the membrane over a surface to ensure that no air
• With the sensor facing down screw the cap clockwise to the end
If any deposit scales the sensors, gently brush the sensor surface with the
supplied scouring pad, while paying attention to not damage the plastic
body.
HI 76409/4
HI 76409/10 Galvanic DO probe with built-in temperature sensor and
HI 76410-0 Protective sleeve for HI 76410 probes series
HI 76410A/P Membrane for HI 76410 probes series, 5 pcs.
HI 7042S
HI 710015
HI 710016
HI 731326
Hanna Instruments reserves the right to modify the design,
construction and appearance of its products without advance
sale@ponpe.com
PROBE MAINTENANCE & CLEANING PROBE MAINTENANCE & CLEANING
PROBE MAINTENANCE & CLEANING PROBE MAINTENANCE & CLEANING PROBE MAINTENANCE & CLEANING
electrolyte solution while shaking it gently. Refill with clean
electrolyte.
bubbles remain trapped.
of the threads. Some electrolyte will overflow.

ACCESSORIES

ACCESSORIES
ACCESSORIES ACCESSORIES ACCESSORIES
Galvanic DO probe with built-in temperature sensor and
4 m cable
10 m cable
Electrolyte solution, 30 ml bottle
Shockproof rubber boot, blue color
Shockproof rubber boot, orange color
Calibration screwdriver (20 pcs)
notice.
18
www.ponpe.com