Advertisement
English-2
●
AC adapter
Misuse of the AC adapter creates the risk of fire and electric shock. Make sure that you always observe the precautions below.
+
•
Make sure that you use a power source with the same voltage as that specified for the AC adapter.
•
Use only the power cord that comes with the Signage Unit.
•
Use only the AC adapter that comes with the Signage Unit.
•
Do not use the power cord that comes with the Signage Unit to power another device.
-
•
Do not use the AC adapter that comes with the Signage Unit to power another device.
•
Do not overload a single electrical outlet with too many devices.
+
Misuse of the AC adapter can damage it and create the risk of fire and electric shock. Make sure that you always observe the
precautions below.
•
Never place heavy objects on the AC adapter and never expose it to heat.
-
•
Never try to modify the AC adapter or subject it to excessive bending.
•
Do not twist the power cord or pull on it.
+
•
Should the power cord become damaged, Contact your original dealer or authorized CASIO service center.
"
Never touch the AC adapter while your hands are wet. Doing so creates the risk of electric shock.
+
Never use the AC adapter while it is wet. Water creates the risk of fire and electric shock.
%
Never place a vase or any other container of liquid on top of the AC adapter. Water creates the risk of fire and electric shock.
●
Water and foreign matter
+
Never allow the Signage Unit to become wet. Water creates the risk of fire and electric shock.
%
Never place a vase or any other container of water on top of the Signage Unit. Water creates the risk of fire and electric shock.
%
Water or other liquid, or foreign matter (metal, etc.) getting into the Signage Unit creates the risk of fire and electric shock. If
the Signage Unit becomes wet, immediately perform the steps below.
1. Turn off power.
2. Unplug the power plug.
3. Request servicing and repair from your original dealer or authorized CASIO service center.
●
AC adapter
Misuse of the AC adapter creates the risk of fire and electric shock. Make sure that you always observe the precautions below.
+
•
Insert the plug into the power outlet as far as it will go.
•
After use unplug the power plug from the power outlet.
•
Unplug the power plug from the power outlet before going on a trip or if you do not plan to use the Signage Unit for a long
time.
•
At least once a year, unplug the power plug and use a dry cloth or vacuum cleaner to clear dust from the area around its
prongs.
•
Do not use the AC adapter while it is covered with a blanket, or located next to a heating device. Such conditions can
-
interfere with heat radiation, and cause local heat build up.
•
When unplugging the power cord, always grasp the plug, and do not pull on the power cord.
•
Never use detergent to clean the power cord, especially the power plug and jack.
D
MG-30MBPACK_e.indd
2
Caution
●
Battery
Misuse of batteries can cause them to leak and stain the area around them, or to explode, creating the risk of fire and personal injury.
Make sure that you always observe the following precaution.
-
•
Use only the battery type specified for the remote controller.
+
•
Remove the battery from the remote controller as soon as possible after it goes dead.
•
Remove the battery from the remote controller if you do not plan to use it for a long time.
●
Disposing of batteries
Make sure that you dispose of used batteries in accordance with the rules and regulations in your local area.
●
Cleaning the interior of the Signage Unit
Allowing dust to build up inside the Signage Unit by not cleaning it for long periods creates the risk of fire and accident, and can cause
loss of projection luminosity. Periodically clean the interior of the Signage Unit.
Laser Precautions
The projector built into the Signage Unit is a Class 1 laser device that conforms to IEC 60825-1.
The Signage Unit has a built-in laser module. Disassembly or modification is very dangerous and should never be attempted.
Operating Precautions
●
Do not use or store the Signage Unit in any one of the locations described below. Such locations create the risk of malfunction of and
damage to the Signage Unit.
•
Locations exposed to direct sunlight
•
Outdoors or locations where there are large amounts of dust
•
Locations subjected to large amounts of oil smoke or other smoke
•
Locations subjected to vibration
•
Near water (fountains, etc.) or other locations where there is risk of wetting
•
Near heating equipment or other sources of high temperatures
•
Near shop entrances or stairways
●
Note the precautions below when selecting a location for the Signage Unit.
•
Avoid locations where the Signage Unit could be tripped over or otherwise interfere with foot traffic.
•
When routing cables, take care to select locations where there is no chance of their being tripped over.
•
Take care to locate the Signage Unit and screen where individuals (especially children) cannot touch them or hang from them.
●
Do not look directly into the light emitted from the Signage Unit.
●
Should you ever notice a component has dropped out of the Signage Unit, immediately stop using it and contact your original dealer or
authorized CASIO service center.
●
Should you ever notice breaks or cracks in the screen, immediately stop using it and contact your original dealer or authorized CASIO
service center.
●
Use under high ambient temperature or in environments subjected to large amounts of dust, oil smoke, tobacco smoke, or other types
of smoke can shorten the replacement cycles and require more frequent replacement of the optical engine and other components. Note
that you are charged for such replacement. For details about replacement cycles and fees, contact an authorized CASIO service center.
●
Ensure that the remote control signal receiver is not exposed fluorescent light, sunlight, or other strong light. Strong light can cause
malfunction.
●
When projecting, adjust the position of the screen so that width of black space surrounding the projected image in the screen becomes
even.
●
When cleaning the unit, always use a soft and dry cloth. Do not use a wet cloth or solvent.
2014/08/25
15:09:23
Advertisement
