Operating A Device With Your Programmed Remote Control (Rf) - Samsung SIR-TS360 Owner's Manual

8
8
CHAPTER 8
Programming the remote control
Enter the three-digit code for your device (see the code lists on the "Remote Control" manual)
4
If the entered code is correct, the device will turn off.
Press the device button again. The button should blink twice and then turn off.
5
Repeat the procedure for other devices you wish to operate with your DIRECTV
6
RF remote control.

Operating a device with your programmed remote control (RF)

To operate a device using your programmed RF remote control, you must first press the
corresponding device button (TV, VCR or DIRECTV).
Then use the RF remote control to operate that device.
The RF remote control will continue to operate that device until you press another device
button. Each time you want to button to a different device with your RF remote control,
you start by pressing a device button.
NOTE
When working with the TV and VCR device remote control, the IR signal will be transmitted.
Therefore, you need to at the device to work with.
® HD Receiver's