Advertisement
Quick Links
A
A
B
I
Component Identification
Description
A
HOSE CLAMP; #48
B
HOSE; 3"ID X 2"L REINFORCED
C
TUBE; INTAKE, 40%-758
D
HOSE CLAMP; #60
E
HOSE; 3.75"ID X 2.25"L
F
HOSE CLAMP; #64 STAINLESS
G
HOSE; 4"ID X 2"L REINFORCED
H
AIR FILTER
I
GROMMET; 1"OD,1/2"ID,1/2"THK
Full color instructions can be viewed on our web site at Airaid.com. If you need any assistance please call 1-800-498-6951 to speak with
TO START:
1. Turn off the ignition and disconnect the negative
battery cable.
NOTE: Disconnecting the negative battery cable
erases pre-programmed electronic memories. Write
down all memory settings before disconnecting the
negative battery cable. Some radios will require
an anti-theft code to be entered after the battery is
reconnected. The anti-theft code is typically supplied
with your owner's manual. In the event your vehicles
anti-theft code cannot be recovered, contact an
authorized dealership to obtain your vehicles anti-
theft code.
2. Disconnect the inlet air temperature sensor electrical
connection.
C
F
G
F
Qty.
Part #
2
08601
1
08711
1
KIT758A
2
08624
1
08760
2
08645
1
08761
1
860/861-397
1
08064
a representative in our Customer Service Center before returning the product.
3. Loosen the hose clamp that secures the factory intake
tube to the upper air filter housing.
4. Release the locking clamps, lift up the upper air
filter housing and then remove it from the vehicle, then
remove the factory air filter.
Installation Instructions
For Part Numbers:
400-758
860-397 Airaid Oiled Media Filter
401-758
861-397 SynthaMax Dry Media Filter - Red
2018 FORD F150 / F150 Raptor / Expedition
2018 LINCOLN Navigator
V6-3.5L
NOT LEGAL FOR SALE OR USE ON ANY POLLUTION
CONTROLLED MOTOR VEHICLE IN CALIFORNIA OR
STATES ADOPTING CALIFORNIA EMISSION PROCEDURES.
See Airaid.com for CARB status on each part for a specific vehicle
D
E
D
H
FACTORY
PART
5. Loosen the two remaining hose clamps that secure
the factory intake tube to the turbo inlet tubes and then
remove the intake tube from the vehicle.
NOTE: AIRAID recommends that customers do not
discard factory air intake.
7. Install the provided coupler hose (08761) onto
the driver's side turbo inlet tube and secure with the
provided hose clamp.
FACTORY
PART
Advertisement
Related Manuals for Airaid 400-758
Summary of Contents for Airaid 400-758
- Page 1 860/861-397 GROMMET; 1"OD,1/2"ID,1/2"THK 08064 Full color instructions can be viewed on our web site at Airaid.com. If you need any assistance please call 1-800-498-6951 to speak with a representative in our Customer Service Center before returning the product. TO START: 1.
- Page 2 Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are missing, or were damaged during shipping. If any parts are missing, contact Airaid.