Stanley FG10 User Manual page 12

PREVENTATIVE MAINTENANCE
1. The gears and bearings in the ram, spindle and housing assemblies should be re-greased every 6 months or
500 hours, This procedure must be accomplished by a trained technician.
2. After each servicing, measure the spindle speed (rpm - revolutions per minute) at 12 gpm/45 lpm input. The
nominal speed is 4000, not to exceed 6000 rpm. This procedure must be accomplished by a trained technician.
3. Inspect the spindle and drive flange for signs of wear or damage. Run-out should not exceed .004 in./.1 mm TIR
on threads or .002 in./.05 mm TIR on arbor diameters and faces.
4. Check hoses and fittings weekly for any evidence of leakage, cover wear, cracking or cuts. If any of these
defects are found, discontinue use of the tool immediately and have the defects repaired or replaced by a
trained technician.
5. To grease between main housing bore (item 73) and the ram outer diameter (item 26), 1 - 2 pumps of grease
are required at these locations. Too much grease will lockup the feed assembly (See figure 4 below).
12 ► FG10/PG05 User Manual
OPERATION
Figure 4