Livorsi GPSS Series Installation Instructions

INSTALLATION
1.
If you are using the supplied antenna, find a mounting location that will maintain an unobstructed view of the satellites. The
antenna must be kept parallel to the horizon, plastic cover facing up.
2.
Hidden installation of the antenna is possible and can be determined by temporarily mounting the antenna in the desired
location and checking the signal. Due to the differences in dash or deck thickness and materials, results are difficult to
predict. The signals will not pass through metal, but may pass through glass and plexi windshields. Additionally, try to keep
the antenna away from any aluminum or stainless frames.
3.
Once a location is chosen, drill a 3/8" (9.5 mm) opening in the mounting panel.
4.
Slide the antenna cable in to the opening and secure the antenna with silicone or double-sided tape. The Antenna should be
removable in case battery goes dead. There is an internal battery in some older antennas that holds the memory and has a
shelf life of 3 to 5 years. Antenna must be sent back to the factory for replacement. .
5.
If you are using an alternative antenna, make certain that its wiring is compatible with the gauge and proceed to step 6.
6.
Find a suitable location for the recall switch, drill a ½" (12.5 mm) opening in the panel.
7.
Center the opening in the panel with the opening on the cover plate, and mark the centers for the screws that will secure the
cover plate to the panel. Secure the cover plate.
8.
Make the appropriate connections on the switch.
Purple wire to the center terminal
Orange wire to the outside terminal on the same side as the "Recall" mark on the switch plate
Gray wire to the remaining terminal
WARNING: Make certain that the purple wire is always connected to the center terminal. SHORT- CIRCUITING OF THE
ORANGE AND GRAY WIRES MAY LEAD TO CIRCUIT FAILURE AND WILL VOID THE WARRANTY!
9.
Fit the switch in to the opening, screw on the protective boot, and secure the switch with the nut from the other side of the
panel.
10.
Cut out a 4 5/8" (117 mm) opening in the dash board for a GPSL series gauge
Or a 3 3/8" (86 mm) opening for a GPSS series gauge.
11.
If possible, slide the wiring harness, through the opening and make all the electrical connections prior to fitting the gauge in
to the panel. Otherwise mount the gauge first, and then make appropriate connections.
WARNING: Improper wiring may damage the gauge and/or the antenna. Incorrect connections will void the warranty!
12.
Fit the gauge in to the opening and rotate it to the desired position.
13.
Slide the clamp over the mounting studs, and secure the clamp with provided kep nuts. Torque the nuts to 4-6 in-lbs
GPSL SERIES INSTALLATION
Wire Harness
www.livorsi.com/auto
Ground
Black wire from antenna
Signal In
Orange wire from antenna
Red wire from antenna
12 V Out
4-6 in-lbs (0.45-0.65 Nm)
GPSS SERIES INSTALLATION
GPS SPEEDOMETER
INSTALLATION INSTRUCTIONS
Ground
Black wire from antenna
Orange wire from antenna
Signal In
Red wire from antenna
12 V Out
Wire Harness
4-6 in-lbs (0.45-0.65 Nm)