Table of Contents
Advertisement
Read
assembly
and
setup
attempting assembly. Failure to comply may
cause serious injury.
5.0 Setup and assembly
5.1 Shipping contents
See Figure 5-1
1
Abrasive Notcher
1
Abrasive belt (80-grit) preinstalled
1
Set of 3 abrasive belts (36,60,80-grit)*
7
Rollers (one roller is pre-installed)
1
Open end wrench, 22/24mm
3
Hex wrenches, 4,6,8 mm
1
Operating instructions and parts list
1
Product registration card
5.2 Unpacking and locating
1.
Inspect contents for shipping damage. Report
damage, if any, to your distributor. Do not
discard shipping materials until Notcher is set
up and running properly.
2.
Compare contents of shipping carton with the
contents list above. Report shortages, if any, to
your distributor.
3.
The Abrasive Notcher should be located on a
sturdy, level floor in a dry environment, with
good overhead lighting and room enough for
loading and offloading of stock, and general
maintenance.
4.
Lift machine using hook or straps through lifting
plate (Figure 5-1). Make sure lifting equipment
capacity exceeds maximum weight of Notcher.
Machine is heavy; use
appropriate lifting device and exercise
caution when moving to final location.
Failure to comply may cause serious injury.
Figure 5-1
and
understand
all
instructions
before
5.
It is recommended that Notcher be bolted to
floor, using lag screws or similar means. See
mounting pattern, Figure 4.1.
6.
Remove rust protectant from exposed surfaces
with a clean rag and cleaner/degreaser or
kerosene. Avoid getting solvents on rubber or
plastic parts.
IMPORTANT: The vise handle (see A, Figure 7-1)
has been tightened for shipping purposes. To allow
proper operation, loosen screw (A
about two revolutions.
6.0 Electrical connections
Electrical connections must be
made by a qualified electrician in compliance
with all relevant codes. This machine must be
properly grounded to help prevent electrical
shock and possible fatal injury.
The DSAN4-1 is pre-wired for 230 volt, single-
phase operation. It is recommended that the
DSAN4-1 be connected to a dedicated 25 amp
circuit with circuit breaker or fuse.
The DSAN4-3 is prewired for 230 volt, three-phase
operation, but can be converted to 460 volt, three-
phase operation (see sect. 6.1). It is recommended
that the DSAN4-3 be connected to a dedicated 15
amp circuit with a circuit breaker or fuse.
NOTE: Local codes take precedence over
recommendations.
These machines are not provided with a power plug;
you may either attach a proper UL/CSA-listed plug,
or "hardwire" the machine directly to a service panel
(make sure a disconnect is available to the
operator).
If hardwired:
Permanently connected tools: This tool should be
connected to a grounded metal permanent wiring
system; or to a system having an equipment-
grounding conductor.
6.1 Converting to 460V (DSAN4-3
only)
The DSAN4-3 (3 phase model) can be converted to
460 volt input, as follows:
1.
Disconnect machine from power source.
2.
Remove rear panel, and replace the 230-volt
thermal relay with a 460-volt thermal relay (part
no. DSAN4-3-128-460, contact JET to order).
3.
Reconnect the wires on the transformer from
230V to 460V position. See sect. 12.0
diagrams.
7
, Figure 7-1)
1
Advertisement
Table of Contents
