Advertisement
FCC notices:
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Christmas tree
With model PDC series
or PDR series controller
FCC ID: 2AABT-CW003
Outfit
With model PDC
series or PDR series
controller
LxGxYxS (First X = 30-120, second X=0-5, thirdly X=0100-2300)
Note:
"L" means that the low voltage.
The first "x" indicates the size of the tree, said the use of height from
3ft-12ft.
"Gx" number of lines, G0 represents 0 drag line G5 on behalf of 5 drag line.
"Y" means tree stand. M means the tree is to use ordinary tree foot. R which
means that the tree is to use rotating tree foot.
The third "x" represents the number of lamp, from 100 to 2300 lamp.
"S" means that the tree pin.
LIxYx (First X=06-220, second X=010-2300)
Note:
"L" means that the low voltage.
"I" indicates for indoor use only, if blank means for indoor and outdoor use.
The first "x" indicates the size of Wreath/Garland/Teardrop/Tree/Swag, the
size is from 06 in - 220 in in for Wreath/Teardrop/Tree/Swag; the size is
from 06 ft - 50 ft in for Garland.
"Y" means type of product. "W" which means wreath. "G" which means
Garland. "TD" which means teardrop. "T" which means tree. "S" which
means swag.
The second "x" represents the number of lamp, from 10 to 2300 lamps.
Advertisement
