Living Earth Crafts CLOUD 9 Operation Manual page 7

Helpful Suggestions on Positioning your Cloud 9
For Pedicures: Begin with the Cloud 9 at its lowest height setting. The back rest
should be raised to a comfortable position. Before the client is in the chair, remove the
footrest, then raise the thigh section approximately 3 inches. Next, lower the footrest
section all they way down. Positioning the chair in this order will prevent a "sliding off"
sensation for your client.
For Massage: There are two support bars located underneath the thigh section.
These were designed to provide extra stability when the Cloud 9 is used in the flat,
massage position. You can locate these support bars at the foot end of the table,
underneath the shroud. The Thigh Section must be raised approximately 2 inches
before the support bars can be used. Be sure to slide them back into the shroud when
not in use.
CAUTION!
The support bars described above must be in use when ever there
is weight in excess of 15 lbs placed on the thigh section. Without
these support bars in place the thigh section is NOT a weight
bearing surface. Sitting, or placing excess weight, on the thigh
section without these bars in place may void your warranty.
Removable footrest section is not a weight bearing surface. Weight
placed on the footrest should never exceed 35lbs
Never try to lower the calf section of your table lower than flat while
the support bars are extended. This could damage your table and
void your warranty.
6
Operation manual – Cloud 9
03/05/08