Download Print this page

DigiGrid DESKTOP INTERFACE Quick Start Manuals

WHAT'S IN THE BOX

DESKTOP INTERFACE

Plug in and connect the included power supply. Connect your computer's network port to your Desktop Interface.

If your computer doesn't have an RJ45 network port, use a Thunderbolt or USB3 adapter. Please contact tech support for

more information

ARE YOU AN EXISTING DIGIGRID CUSTOMER OR USING A POE SWITCH?

You can connect your new DiGiGrid Desktop Interface to your existing DiGiGrid setup. Just connect to a free port.

If you have our PoE switch, this will also provide the power to your desktop interface

You must register your DiGiGrid Desktop Interface in order to get the software, drivers, and any licenses needed.

To register your device, log into your Waves account at www.waves.com. If you don't have a Waves account, please

create one here:

www.waves.com/create-account

Go to

Waves.com

> Downloads >

installer and follow the onscreen instructions when finished.

POWER SUPPLY

Latest Version

and Download

Quick Start Guide

CAT5E CABLE

Waves Central

for Mac or PC, as needed. Run the

QUICK START GUIDE

Table of Contents

Need help?

Do you have a question about the DESKTOP INTERFACE and is the answer not in the manual?

Page 1 ARE YOU AN EXISTING DIGIGRID CUSTOMER OR USING A POE SWITCH? You can connect your new DiGiGrid Desktop Interface to your existing DiGiGrid setup. Just connect to a free port. If you have our PoE switch, this will also provide the power to your desktop interface REGISTER AND DOWNLOAD SOFTWARE You must register your DiGiGrid Desktop Interface in order to get the software, drivers, and any licenses needed.
Page 2 Choose “NEXT” to start automatic configuration. This will take a few moments. Choose “CANCEL” to configure manually. If the Wizard cannot locate your DiGiGrid Interface, then check they are turned on and connected properly. In such a case the Wizard will allow you to rescan the network or work as a Driver node slaved to another system.