Advertisement
The ARLP-M-KIT is a field installable motorized latch retraction kit for the Adams Rite 8000 series.
A.
AR L P- M - K I T I
A.
Attaching Bracket
B.
8' Power Lead
C.
Motor Mount w/ MM series Module
D.
Super Lube Grease
E.
Allen Wrench 5/64
U.S. Customer Support
1-888-622-2377
ARLP-UL-M-KIT
I
n s ta l l at I o n
C.
B.
n c L u d e s
I
nsTALLATIon
s
cAn oR
Visit our website for more details
www.CommandAccess.com
I
n s t r u c t I o n s
T
o o L s
• Phillips Screwdriver
V
Ideo
c
LIcK
D.
E.
R
e q u I R e d
Canada Customer Support
1-855-823-3002
Doc # 20225_C
1
Advertisement
Table of Contents
Related Manuals for Command access ARLP-UL-M-KIT
Summary of Contents for Command access ARLP-UL-M-KIT
- Page 1 ARLP-UL-M-KIT n s ta l l at I o n n s t r u c t I o n s The ARLP-M-KIT is a field installable motorized latch retraction kit for the Adams Rite 8000 series. AR L P- M - K I T I...
- Page 2 T E C H N I C A L I N F O R M A T I O N pecificationS MM4 Switches • Input Voltage: 24VDC +/- 10% • Average Latch Retraction Current: 1.3 Amp • Average Holding Current: 170 mA •...
- Page 3 Ceiling Tile Module Legend Standard Placement ecommenDeD ower uPPlieS All Command Access exit devices & field installable kits have been thoroughly cycle tested with Command Access power supplies at our factory. For more information click here or go to our website...
- Page 4 • Slide the push pad back until it clears the front activating bracket. • Slide forward to remove push pad. • Remove the dogging assembly and slide off the push pad. *Recommended but not required • Cover the 2 pins with super lube provided to top, bottom and end of 2 points on attaching bracket.
- Page 5 • Drop the front arms onto the back activating bracket. • Extend ball screw all the way. Not extended Fully extended • Make sure scissor brackets are at an angle so the motor mount can easily fit into the baserail. Note: Be careful loosening screws as scissors will fall off.
- Page 6 • Slide motor all the way to the back of the device. • Visually confirm the hooks will clear the bottom the devices activating bracket ( the gold strip). • Push down on activating bracket (1) then push down on motor mount hooks (2) to snap into place.
- Page 7 • To set the motor assembly in the proper location. Depress the activating brackets all the way down. Confirm nothing is preventing them from fully depressing. Where the assembly stops is the spot, hold the motor here. • With Allen wrench provided, Push tab back until screws line up.
- Page 8 • Without the push pad installed. Attach to power and test to confirm motor is functioning. • Re-install push pad by inserting into the back activating bracket first. • After clearing the front activating bracket up slide forward securing the pad to the front activating bracket.
Need help?
Do you have a question about the ARLP-UL-M-KIT and is the answer not in the manual?
Questions and answers