Advertisement
Alarms
The Alarm LED will illuminate in the following two conditions:
• high or low pressure switches are off longer than 10 minutes
• high or low pressure switches are off 5 times per 10 minutes
(flash on and off).
In both cases, the unit will switch to the Ventilation mode.
To restart the unit, press twice the key ON/OFF (1) to switch OFF
and ON the unit.
ATTENTION: If the alarm comes up again, don't
restart and see your nearest dealer for service.
CAUTION: The unit can automatically start and run
anytime the ignition key is in the ON or OFF position.
No matter if the ON/OFF switch is ON or OFF
(depends on setup program).
Warranty Instructions
Should you require warranty service during the warranty period,
simply present your copy of the Warranty Certificate at any of the
dealer locations shown in the Thermo King Service Directory.
Terms of the complete Thermo King Corporation Warranty are
available on request.
CAUTION: This is a driver's reference guide.
If further information is required, consult your
Thermo King service directory for the location
and phone of the local dealer.
Controller
AJA831
Operator's
Manual
TK 51711-3-PC (10-05)
Copyright © 2005 Ingersoll-Rand Climate Control ESA
BEA114
Alarms
Advertisement
Table of Contents
Related Manuals for Thermo King ClimaAIRE BEA114
Summary of Contents for Thermo King ClimaAIRE BEA114
- Page 1 Should you require warranty service during the warranty period, simply present your copy of the Warranty Certificate at any of the dealer locations shown in the Thermo King Service Directory. Control Panel Descriptions Terms of the complete Thermo King Corporation Warranty are Operating Instructions available on request.
- Page 2 Operating Instructions Turn the system ON by pressing key ON/OFF (1). Use the keys MODE (2), SPEED (3) and AIR MODE (4) to adjust the system. By pressing the selection key you select one of the options in the same group. In Auto Mode all functions are controlled by the ClimaAIRE AJA831 controller automatically according to the required setpoint.
Need help?
Do you have a question about the ClimaAIRE BEA114 and is the answer not in the manual?
Questions and answers