Thermadyne Fabricator 252i US Assembly Instructions

Thermadyne Holdings Corporation
Suite 300, 16052 Swingley Ridge Road
St. Louis, MO 63017, USA
Telephone: 1-800-426-1888 • Fax: 1-800-535-0557
Email: sales@thermalarc.com
www.thermalarc.com
Kit Componants
The following components are included in this kit.
• Control Panel PCB Assembly
• Anti Static Strap
• Mounting Screws (4)
• Instructions

Control PCB Replacement

This process is the same for the Fabricator and the Transmig units. Transmig is shown in these in-
structions.
1. Disconnect power from the power supply
2. Locate the anti static strap in this kit and follow instructions for proper use and fit it to your body.
3. Remove four (4) Control Panel screws (#1).
© 2012 by Thermadyne Industries
0-5248 Rev AB
CONTROL PCB REPLACEMENT INSTRUCTIONS
Figure 1: Front Panel Screw Removal (Transmig shown)
Control PCB Replacement and
Fabricator 252i US W7005381
Fabricator 252i EU W7005388
Transmig 250i W7005336
NOTE
#1
Art # A-1
1
Manual 0-5248
Part Numbers for
Assembly Instructions
May 16, 2012