Thermadyne Fabricator 211i Assembly Instructions

Thermadyne Holdings Corporation
Suite 300, 16052 Swingley Ridge Road
St. Louis, MO 63017, USA
Telephone: 1-800-426-1888 • Fax: 1-800-535-0557
Email: sales@thermalarc.com
www.thermalarc.com

Spool Hub Assembly Installation

The following components are included in this kit.
7
6
1. Install parts numbered 1 to 6 over the axle in the sequence shown above. Align the flat edge of the Fibre
Washer with the flat edge of the recess in the Spool Hub.
2. Install the Tri-lobe Nut (7) into the Axle through parts numbered 6, 5, 4 and 3.
3. Insert the Retaining Clip (8) into one of the set holes on the Spool Hub (2).
Normally, the Spool Hub Assembly has been installed to the power source as delivered from the fac-
tory. These installation procedures are designed for future replacement.
© 2011 by Thermadyne Industries
0-5223
Item Description
1 Fibre Washer
2 Spool Hub
3 Flat Washer Large Hole
4 Keyed Washer
5 Spring
6 Flat Washer Small Hole
7 Trib-lobe Nut
8 Retaining Clip
8
2
3
4
5
SPOOL HUB ASSEMBLY INSTRUCTIONS
Spool Hub Assembly for
Part Number: W7005311
1
Axle
NOTE
1
Manual 0-5223
Fabricator 211i & 252i
Transmig 200i & 250i
Assembly Instructions
Qty
1
1
1
1
1
1
1
1
Art # A-10929
December 22, 2011