Setting Up The Transmitter - Acoustic Research AWD205 Owner's Manual

Setting Up the Transmitter

The 2.4GHz wireless transmitter works with a wide variety of audio
sources, from portable MP3 players to A/V receivers to DVD players or
gaming systems. It can even connect to your computer's USB port to
deliver 100% digital audio. The way you set it up depends on the kind
of output you want to use on your audio source.
Using the built-in audio cable:
4
Transmitter (back panel)
If your audio source has stereo RCA
outputs: Connect the red and white plugs
of a stereo Y adapter cable (not included) to
the audio source's line out jacks. Connect the
other end of the stereo Y adapter cable to the
transmitter's built-in audio cable.
Note: High-output sources, such as DVD players or audio receivers/
amplifiers, may cause distortion if used at full volume with the
transmitter. Try setting them at 1/2 or 2/3 volume.
G
1
2
3
ettInG
1. Plug the transmitter's
built-in audio cable into
the headphone jack on
your audio source.
2. Set the ANALOG/
USB switch on the
transmitter's back panel
to ANALOG.
3. Connect the end of the
AC power adapter with
the USB connector to the
USB Power In jack on the
transmitter's back panel.
4. Plug the adapter into an
electrical outlet.
Important: This power
unit is intended to be
correctly oriented in a
vertical or floor mount
position.
S
tarted
5