Samsung SNC-B2331(P) User Manual page 78

appendix
PROBLEM
I enabled Motion Detection Feature
under Motion Detection, but .jpg
files are not getting sent over FTP/
SMTP even after motion detection
occurs at the FT camera.
Is it possible to configure Motion
Zone with Motion Detection
Feature disabled?
A motion event took place but
didn't trigger an alarm.
78_ appendix
Verify the settings in the following sequence:
A. NTP must be properly configured.
B. Motion Detection Feature must be enabled.
C. Alarm Video Transmission must be enabled.
D. Check for scheduling conflict.
Yes. Motion Zone can be configured independently of whether or not
Motion Detection Feature is in use.
Check alarm output port settings.
SOLUTION