Table of Contents
Advertisement
2.1 OPERATING ENVIRONMENT
You can install the equipment in a standard component rack or on a suitable surface such as a bench or desk.
In any case, the area should be as clean and well-ventilated as possible. Do not locate the equipment directly
above a hot piece of device. The upper lid can be dismounted to allow an easy internal access. The equipment
is designed with a modular design, that is each circuit is realized inside different modules or boards. All
interconnections between modules are made by means of connectable cables which allow an easy and quick
maintenance of demaged modules.
2.2 FIRST INSTALLATION
Correct installation of the equipment is important for maximum performance and reliability. Antenna and earth
connections must be installed with the greatest care. The equipment adjustment isn't need, because the unit is
completely adjusted by our technical staff.
RF INPUT
To ELECTRIC NETWORK
AC 400V IN
RS485
AGC
TELEMEASURES
RF IN
BREAKER
AC 200V OUT
To EXCITER
To ANTENNA
RF OUT
1. Connect Power Supply cable of the Exciter to the Auxiliary Socket on the rear panel of the Amplifier;
2. connect the Power Supply cable of the Amplifier to the electric network (230VAC Monophase or 400VAC
Threephase); if present the Isolator Transformer, the Amplifier is provided with cable and plug;
3. connect the RF OUT Exciter cable to the RF IN connector on the rear panel of the Amplifier;
4. connect the Antenna cable to the RF OUT connector on the rear panel of the Amplifier.
100
Advertisement
Table of Contents
