Davies Craig Thermatic Fanwiring To The Digital Controller; Ewp Digital Controller; Technical Specifications - Davies Craig EWP-FAN Installation Instructions Manual

Davies Craig Thermatic FanWiring to the Digital Controller

Please follow the below instructions 1&2 if you are using the wiring loom provided with Davies Craig
Thermatic Fan.
1. Cut the green wire from the Fan wiring loom to a sufficient length, this wire (with relay) to be joined with the
black traced green wire from the Digital Controller
2. Cut the black wire before the ring terminals attached, and then join sufficient length of wire to connect the
battery positive as shown in the diagram below (85). Please discard the ring terminal part.
Fig.7
Input Voltage
Output Voltage
Max. Current
Operating Temperature
Setting Temperature
Controller Type
Sensor Type
Time Out
Indicator LED‟s
Weight
Dimensions
Wire - Green with black stripe
from controller
86
30
Relay
y
Rela
Red
Battery +ve Battery

EWP DIGITAL CONTROLLER

Technical Specifications:

Fan Motor Fan FAN
Motor
87 Blue
85
Black
+ve
12V DC to 15V DC
6V to 13.5V
12A
-20ºC to 60ºC (-5ºF to 140ºF)
75º, 80º, 85º, 90º, 95ºC
(165º, 175º, 185º, 195º, 205ºF)
PCB with Micro Processor
Thermistor in waterproof housing
2 Min. (or Set –5ºC) after ignition OFF
Temp., Power ON, Pump mode, Fan and Test
90 grams (3.2 oz.)
101mm (L) X 95mm (W) X 35mm (D)
[4" (L) X 3-3/4" (W) X 1-3/8" (D)]
Page 8 of 8