Safety Instruction - Wild tech WT-KLD User Manual

2. Safety Instruction

Please read carefully the instruction, which includes important information about
the installation, usage and maintenance.
WARNING
User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this
instruction booklet.
♦
Unpack and check carefully there is no transportation damage before using the unit.
♦
Before operating, ensure that the voltage and frequency of power supply match the power requirements of the
unit.
♦
It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
♦
The unit is for indoor use only. Use only in a dry location.
♦
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces. Be
sure that no ventilation slots are blocked.
♦
Disconnect mains power before fuse/lamp replacement or servicing.
♦
Replace fuse/lamp only with the same type.
♦
Make sure there is no flammable materials close to the unit while operating as it is fire hazard.
♦
Use safety cable when fixes this unit.
♦
Maximum ambient temperature is TA: 40 . Don't operate it where the temperature is higher than this.
♦
Unit surface temperature may reach up to 85 . Don't touch the housing bare-hand during its operation. Turn off
the power and allow about 15 minutes for the unit to cool down before replacing bulb or serving.
♦
In the event of serious operating problem, stop using the unit immediately. Never try to repair the unit by
yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the
nearest authorized technical assistance center. Always use the same type spare parts.
♦
Don't connect the device to any dimmer pack or power pack.
♦
Do not touch any wire during operation as high voltage might be causing electric shock.
♦
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or moisture.
♦
Never touch bulb with bare fingers as it is very hot after using.
♦
Hot lamp explosion hazard. Do not open the unit within five minutes after switching off.
♦
Do not start on the unit without bulb enclosure or housing are damaged.
♦
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly damaged.
♦
Do not look directly at the light while the bulb is on.
There are no user serviceable parts inside the unit. Do not open the housing or attempt any repairs yourself.
In the unlikely event your unit may require service, please contact your nearest dealer.
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the
unit is secure and is able to support a weight of 10 times of the unit's weight. Also always use a safety cable
that can hold 12 times of the weight of the unit when installing the fixture.
The installation must be carried out by qualified service people only. The device should be installed out of
reach of people and outside areas where persons may walk by or be seated.
3. WT- KLD
Warning
Caution
Rigging the fixtures
♦
Please keep this
Page 3