Samsung RS2533SW Owner's Manual And Installation page 29

INSTALLATION OF THE WATER DISPENSER LINE
Adjust the amount of water supplied.
1) In order to set the display panel to the option mode, press the Freeze
Temp. and Power Cool buttons at the same time for about 12 seconds
until the temperature display panel switches to the option mode and you
hear a beep.
2) A number under "Fridge Temp." corresponds to the option number. Press
the Fridge Temp. button to increase the number and the Power Cool but-
ton to decrease the number. Set the option number 3.
Option number
3) Now, you have to select the "Input Data" to control the water supply time.
Press the Freeze Temp. button to increase the value. Press the Power
Freeze button to decrease the value.
Choose the right amount of water supplied to the ice tray
4) Wait until the display panel automatically switches back to the control
mode.
Input Data
5) Check the amount of water supplied to the ice tray as shown
When setting the "Input Data" do not select the
largest number. The largest number may cause a
NOTE
overflow. Proceed step by step.
CHECK THE WATER LEVEL
OPTIMUM
LEVEL
29
Input Data Water Supply Time (sec)
00 5
01 4
02 3
03 6
04 7
05 8
06 9
07 10
08 12
09 13
10 15
11 17
12 19
13 21
14 23
15 25