Advertisement
Table of Contents
This is a factory replacement kit. The blowers are aftermarket
models with LIMITED INSTRUCTIONS!
Intended to be installed by a qualified technician.
The
BLOTBLDV & BLOTSDV
enhance heat output.
The fan kit operates on 120 VAC, 60 Hz power.
factory installed junction box. Plug corset into outlet marked "auxiliary". The junction box is located in
the controls compartment of the appliance.
Because the blower is thermally activated, when turned on, it will automatically start approximately 10
minutes after lighting the fireplace and will run for approximately 30-45 minutes after the fireplace has
been turned off.
Use of the fan increases the output of heat.
penetrate into the blower bearings, causing irreparable damage. Care must be taken to
prevent drywall dust from coming into contact with the blower or its compartment. Any
damage resulting from this condition is not covered by the warranty policy.
Installation Precautions
The
BLOTBLD/BLOTSDV
It is your responsibility to read all instructions before starting installation and to follow these instructions
carefully during installation to ensure maximum benefit from, and safe operation of the fan.
Shock Risk / Explosion Risk
- DO NOT wire 110-120 VAC to gas control valve
- DO NOT wire 110-120 VAC to wall switch
NOTE:
grounded in accordance with local codes, or in the absence of
local codes, with National Electric Code ANSI/NFPA 70-
latest edition or the Canadian Electric Code CSA C22.1
Sharp Edges
INSTALLATION INSTRUCTIONS
PayandPack.com
info@payandpack.com
BLOTBLDV / BLOTSDV Fan Kit
Fan Kit has been designed to circulate room air through the appliance to
This is available through a receptacle in the
is tested and safe when instal led in accordance with this installation manual.
WARNING
•
Incorrect wiring will damage millivolt values
•
Incorrect wiring will override IPI safety lockout and
may cause explosion
This appliance must be electronically wired and
CAUTION
•
Wear protective gloves and safety glasses during
installation
NOT original parts.
CAUTION:
Page 1
Drywall dust will
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for PayandPack Durablow BLOTBLDV
Summary of Contents for PayandPack Durablow BLOTBLDV
- Page 1 INSTALLATION INSTRUCTIONS PayandPack.com info@payandpack.com BLOTBLDV / BLOTSDV Fan Kit This is a factory replacement kit. The blowers are aftermarket models with LIMITED INSTRUCTIONS! NOT original parts. Intended to be installed by a qualified technician. Fan Kit has been designed to circulate room air through the appliance to BLOTBLDV &...
- Page 2 Electrical grounding Instructions: This Electrical connections should only be appliance is equipped with a three-prong performed by a qualified licensed electrician. (grounding) plug for your protection against Main power supply must be turned off before shock hazard and should be plugged directly connecting the fan to the main electrical into a properly grounded three-prong power supply or performing service.
- Page 3 This should be done before framing the fireplace. Wire with minimum 60° C wire in accordance with prevailing codes. ATTENTION! PayandPack.com info@payandpack.com The thermodisc is set to turn on at approximately 120° F and will shut off at approximately 90° F.
Need help?
Do you have a question about the Durablow BLOTBLDV and is the answer not in the manual?
Questions and answers