Page 1
Pro871C Cable Locator Operating Instructions WARNING – Read and understand the instructions before operating this unit. Failure to do so could lead to injury or death.
Page 2
The Armada Technologies Pro871C wire and cable locator is designed to locate underground cables and their paths. The complete Pro871C locator consists of; (1) Pro871R Receiving Wand (1) Pro871T Transmitter and Carrying Case (1) ProH3 Stereo Headset ...
Page 3
Turn the unit on and observe the ON LED to confirm good battery install. The Pro871C receiver also has a LO BATT LED and it acts as a warning that the 9 volt battery is weak. When this LED comes on, monitor the performance of the receiver or just replace the battery.
Page 4
To use the Pro871C inductive antenna (built into the case), the user merely needs to select “induction” on the transmitter control panel after turning it on.
Page 5
Tracing Wire - After the Pro871C transmitter has been properly connected and verified to have a good ground and power, turn on the Pro871C receiver by turning the volume knob on the front of the receiver clockwise. Place the receiver near the operating Pro871C transmitter.
Page 6
Tracing Live Electrical Lines using Passive Mode - The Pro871C receiver has the capability of detecting live electrical AC lines in the ground without connecting to them. This is known as passive mode. In passive mode, no transmitter is used. DO NOT ATTEMPT TO CONNECT THE ALLIGATOR LEADS OR ANY OTHER PRO871C COMPONENT TO LIVE ELECTRICAL LINES.
Page 7
If you are in the desert, a little water at the ground stake may help. The best way to really learn the Pro871C is to use it. Set up a test site at your home or office and get used to how it works. There is...
Page 8
Armada Technologies will repair or replace any component that is returned to Armada Technologies within 12 months of purchase and does not exhibit signs of abuse or misuse. It is Armada Technologies sole discretion to determine this condition. Armada Technologies also reserves the right to require a proof of purchase in order to determine date and validity of purchase.
Need help?
Do you have a question about the Pro871C and is the answer not in the manual?
Questions and answers