Advertisement
PITMAN ARM
INSTALLATION INSTRUCTIONS
(Find proper application listed below)
Figure 1
FA400/FA600 - fits FORD 1980-96 F150/Bronco, 83-97 Ranger/Bronco II, 90-94 Explorer,
80-98 F250/F350, and 99 F250/F350 Super Duties through 2/99. Power steering
required.
FA499/FA699 - fits FORD 99 F250/F350 Super Duty from 3/99 and newer. Power steering required.
See Figure 4 for proper assembly diagram.
Figure 2
JA150 - fits 76-86 CJ5 and CJ7 with manual steering.
JA250 - fits 76-86 CJ5 and CJ7 with power steering.
JA350 - fits 74-86 Cherokee Chief, Grand Wagoneer, Truck series 20,40,J10,J20 4WD with ps.
JA552 - fits 72-75 CJ with 1.5-2.5" lift and power steering.
JA550 - fits 72-75 CJ with 3-4" lift and power steering.
JA652 - fits 72-75 CJ with 1.5-2.5" lift and manual steering.
JA650 - fits 72-75 CJ with 3-4" lift and manual steering.
JA750 - fits 87-96 Wrangler YJ, and 97-up Wrangler TJ with 3-4" lift models with power steering.
JA850 - fits 87-96 Wrangler YJ, and 97-up Wrangler TJ with 3-4" lift models with manual steering.
To install the new pitman arm:
1. Remove the tie rod end from the pitman arm and lower tie rod down.
2. At the upper end of pitman arm, remove the nut and lock washer from the output shaft of the
steering box.
3. With a puller, remove the old pitman arm and install the new arm, being sure to install the lock
washer and nut.
4. Install the tie rod back onto lower end of the pitman arm. Be sure to install the cotter pin after
tightening the nut.
5. Check and retighten nuts periodically.
Figure 1
Steering Sector
Pitman Arm
Drag Link
#I-ARM1 (Rev. 12/00)
Figure 2
Tie Rod
Steering Sector
Pitman Arm
Drag Link
Tie Rod
Advertisement
