Table of Contents
Advertisement
INSTALLING THE INTERNET BRIDGE
10
Indoor unit address setting
The addresses of the indoor units connected to one internet bridge shall be assigned without
overlapping. You can set the indoor unit address as hexadecimal 00 ~ FF.
Note : Indoor unit address setting completed site
- The site that already completed the indoor unit address does not require address setting
again.
Note : Assignment of outdoor unit and indoor unit number
- If the outdoor unit product is Multi V, it is recommended to set the first digit of the address
with outdoor unit number, and set the second digit with indoor unit number, so that the sys-
tem composition and division can be easily identified during the address setting.
The following is an example of assigning addresses to the indoor unit.
Note : How to set the indoor unit's central control address
- According to the indoor unit product or the type of the remote controller, the methods of
setting the central control address may be different, so refer to the indoor unit product or
wired remote controller manual for the address setting.
Outdoor unit (group) number
Multi V
Multi V
PI485
Ventilation device
PI485
Ventilation device
PI485
Indoor unit number
Hide quick links:
Advertisement
Table of Contents
