Using The Printer - Samsung SRP-350 Operator's Manual

1-8. Using the Printer

Control Panel
Button
The button can be disabled by the ESC c 5 command.
Press the FEED button once to advance paper one line. You can also hold down the
FEED button to feed paper continuously.
Panel lights
POWER
The POWER light is on whenever the printer is on.
ERROR
This indicates an error.
PAPER OUT
This light indicates the near end of the paper roll. Install a new paper roll and the
printer Will continue printing.
When the light blinks, it indicates the self-test printing standby state or macro
execution Standby state when the macro execution command is used.
12
Serial Interface(RS-232C, RS-485) Specification
DIP Switch Set 1 Functions
SW FUNCTION ON
1 Auto Line Feed Always
Enabled
2 Reserved -
3 Handshaking XON/OFF
4 Word length 7 bits
5 Parity check Yes
6 Parity selection EVEN
7 Baud rate selection Refer to the Following Table
8
Baud rate selection
Transmission speed
2400 baud
4800 baud
9600 baud
19200 baud
Dip Switch Set 2 Functions
SW FUNCTION ON
1 Emulation STAR
2 Reserved
3 Reserved
4 Reserved
5 Select Print Density Refer to the Following Table
6
7 Reserved
8 Reserved
Print Density
Print Density
1 ( Light )
2
3
4 ( Dark )
OFF DEFAULT
Always OFF
Disabled
- OFF
DTR/DSR OFF
8 bits OFF
No OFF
ODD OFF
ON
OFF
SW – 7 SW – 8
ON ON
OFF ON
ON OFF
OFF OFF
OFF DEFAULT
EPSON OFF
- - -
- -
- -
OFF
OFF
- - -
- - -
SW - 5 SW – 6
ON ON
OFF OFF
ON OFF
OFF ON
13