Printing Quality Problems - Samsung SCX-6x22 User Manual

Condition Possible cause
The The printer cable is
machine loose or defective.
prints, but
the text is
wrong,
garbled, or
incomplete.
The wrong printer
driver was selected.
The software
application is
malfunctioning.
The operating system
is malfunctioning.
Pages print, The toner cartridge is
but are defective or out of
blank. toner.
The file may have
blank pages.
Some parts, such as
the controller or the
board, may be
defective.
When you The setting in the
are using software application
Windows is wrong.
98, the
illustrations
print
incorrectly
from Adobe
Illustrator.
PDF file Incompatibility
does not between the PDF file
print and the Acrobat
correctly- products.
some parts
are missing
in graphics,
text or
illustrations.
Suggested solutions
Disconnect the printer cable
and reconnect. Try a print job
that you have already printed
successfully. If possible,
attach the cable and the
machine to another computer
and try a print job that you
know works. Finally, try a
new printer cable.
Check the application's
printer selection menu to
ensure that your machine is
selected.
Try printing a job from
another application.
Exit Windows and reboot the
computer. Turn the machine
off and then back on again.
Redistribute the toner, if
necessary. See page 13.3.
If necessary, replace the
toner cartridge.
Check the file to ensure that
it does not contain blank
pages.
Contact a service
representative.
Select Download as Bit
Image in the Advanced
Options window of the
graphic properties and print
the document again.
Printing the PDF file as an
image may enable the file to
print. Turn on Print As
Image from the Acrobat
printing options.
Note:
It Will take longer to
print when you print a PDF
file as an image.

Printing quality problems

If the inside of the machine is dirty or paper has been loaded improperly,
you may notice a reduction in print quality. See the table below to clear
the problem.
Condition
Light or faded print If a vertical white streak or faded area appears
on the page:
• The toner supply is low. You may be able to
• The paper may not meet paper
• If the entire page is light, the print resolution
• A combination of faded or smeared defects
• The surface of the LSU part inside the
Toner specks • The paper may not meet specifications; for
• The transfer roller may be dirty. Clean the
• The paper path may need cleaning. Contact
Dropouts If faded areas, generally rounded, occur
randomly on the page:
• A single sheet of paper may be defective.
• The moisture content of the paper is uneven
• The paper lot is bad. The manufacturing
• If these steps do not correct the problem,
14.13
<Troubleshooting>
Suggested solutions
temporarily extend the toner cartridge life.
See page 13.3. If this does not improve the
print quality, install a new toner cartridge.
specifications; for example, the paper is too
moist or too rough. See page 5.3.
setting is too low or the toner save mode is
on. Adjust the print resolution and turn the
toner save mode off. See the help screen of
the printer driver and page 2.5, respectively.
may indicate that the toner cartridge needs
cleaning. See page 13.7.
machine may be dirty. Clean the LSU,
contact a service representative.
example, the paper is too moist or too
rough. See page 5.3.
inside of your machine. Contact a service
representative.
a service representative.
Try reprinting the job.
or the paper has moist spots on its surface.
Try a different brand of paper. See page 5.3.
processes can cause some areas to reject
toner. Try a different kind or brand of paper.
contact a service representative.