Installing Accessories; Precautions When Installing Accessories; Installing A Memory Dimm - Samsung SCX-5x30 User Manual

15

Installing accessories

Your machine is a full-featured one that has been optimized to meet most
of your printing needs. Recognizing that each user may have different
requirements, however, Samsung makes several accessories available
to enhance your machine's capabilities.
This chapter includes:
•

Precautions when installing accessories

•

Installing a memory DIMM

Precautions when installing accessories
Disconnect the power cord
Never remove the control board cover while the power is being supplied.
To avoid the possibility of an electrical shock, always disconnect the
power cord when installing or removing ANY internal or external
accessories.
Discharge static electricity
The control board and internal accessories (network interface card or
memory DIMM) are sensitive to static electricity. Before installing or
removing an internal accessories, discharge static electricity from your
body by touching something metal, such as the metal back plate on any
device plugged into a grounded power source. If you walk round before
finishing installation, discharge any static electricity once again.
Installing a memory DIMM
Your machine has a dual in-line memory module (DIMM) slot. Use this
DIMM slot to install additional memory.
The SCX-5330N has 64 MB of memory and the SCX-5530FN has 96 MB
of memory. Both can be expanded to 320 MB. However, SCX-5530FN
users must remove the preinstalled memory DIMM before upgrading the
memory.
For order information for optional memory DIMMs, see page 12.1.
1 Turn the machine off and unplug all cables from the machine.
2 Grasp the control board cover and slide toward you to open it.
3 Completely open the latch on each side of the DIMM slot. If you are
using an SCX-5530FN, remove the preinstalled memory DIMM.
4 Take out a new memory DIMM from the plastic bag.
5 Holding the memory DIMM by the edges, align the notches on the
memory DIMM with the grooves on the memory DIMM slot.
Note
The notches and grooves illustrated above may not match
those on an actual DIMM and the slot.
15.1
<Installing accessories>
1
1 control board cover
1
2
1
latch
2 memory DIMM