DIGI-STAR EZ3600 Getting Started

For tmr tracker feed management software
Hide thumbs Also See for EZ3600:

Advertisement

EZ3600

Getting Started

For TMR Tracker feed management software
HELLO
Ft. Atkinson, Wisconsin USA
Panningen, the Netherlands
www.digi-star.com
D3699-GB Rev E
Mai 11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EZ3600 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for DIGI-STAR EZ3600

  • Page 1: Getting Started

    EZ3600 Getting Started For TMR Tracker feed management software HELLO Ft. Atkinson, Wisconsin USA Panningen, the Netherlands www.digi-star.com D3699-GB Rev E Mai 11...
  • Page 2 Copyright All rights reserved. Reproduction of any part of this manual in any form whatsoever without Digi-Star’s express written permission is forbidden. The contents of this manual are subject to change without notice. All efforts have been made to assure the accuracy of the contents of this manual. However, should any errors be detected, Digi-Star would greatly appreciate being informed of them.
  • Page 3: Safety During Use

    Caution Check system before use Before you are going to use the Digi-Star weighing system you need to check the proper working of the system by charging all weighing points with a known weight. Digi-Star cannot be held responsible for deviations and problems arising from incorrect use of the weighing indicator, incorrect calibration or settings.
  • Page 4: Operation

    Operation OPERATION Switching on the weighing indicator Press HELLO Enter the user number, if required. Press user Press and hold for 3 seconds to zero balance the weighing indicator. D3699-GB Rev E EZ3600 User' s manual...
  • Page 5: Data Transfer

    DataLink sends data to the weighing indicator The weighing indicator gives a message that all data has been NEW DATA received. ←PC→ Weighing indicator connects with DataLink DL→OUT Weighing indicator sends complete data to DataLink D3699-GB Rev E EZ3600 User' s manual...
  • Page 6: Loading And Feeding In Complete Load Mode

    Press to accept the recipe amounts of the group(s) without adjusting them. If the weighing indicator indicates that the resized recipe exceeds the capacity of the feed mixer, press to ignore this message. D3699-GB Rev E EZ3600 User' s manual...
  • Page 7: Feeding Groups

    After the last group has been fed, following message will appear on the display: Recipe complete. Note: Do not press To feed the groups in a different order, press to select the required group. Press to start feeding this group. D3699-GB Rev E EZ3600 User' s manual...
  • Page 8: Commonly Used Direct Access Numbers

    1. Enter 442. 2. Press 3. Press , until the desired percentage (tolerance) appears on the display: OFF, 0.5, 1 - 5, 7, or 10. 4. Press D3699-GB Rev E EZ3600 User' s manual...
  • Page 9: Delay Time

    4. Press to set the time. 11 36 5. Press Setting the date [DATE] 1. Enter 204. 2. Press 110408 3. Press to move the cursor. 4. Press to set the date. 5. Press D3715-Rev E EZ3600 User's manual...

Table of Contents