Care And Cleaning - GE AHP10 Installation Instructions Manual

Controls
Air Direction
Tilt the louver bank to adjust up and down.

Care and Cleaning

Grille and Case
Turn the air conditioner off and remove the plug from the
wall outlet before cleaning.
Air Filter
The air filter behind the front grille should be checked
and cleaned at least every 30 days or more often if
necessary.
To remove:
Open the inlet grille by pulling downward on the tabs at
the top upper corners of the inlet grille until the grille is in
a 45º position. Remove the filter.
Clean the filter with warm, soapy water. Rinse and let the
filter dry before replacing it. Do not clean the filter in a
dishwasher.
Outdoor Coils
The coils on the outdoor side of the air conditioner should
be checked regularly. If they are clogged with dirt or soot,
they may be professionally cleaned.
How to Insert the Battery in the Remote Control
1. Remove the screw on the back of the battery cover.
2. Pinch the slide lock and pull the battery tray out at the
same time.
3. Insert new battery, making sure that the (+) and (–) of
battery are installed correctly.
4. Reinsert the battery tray and reinstall the screw.
6
To clean, use water and a mild detergent. Do not use
bleach or abrasives.
CAUTION
DO NOT operate the air conditioner
without a filter because dirt and lint will clog it and reduce
performance.
NOTES:
Remove the battery from the remote control if the
system is not going to be used for a long time.
49-7823