Kennedy 50230 Assembly & Instruction Manual

Thank you for purchasing this product. We produce quality built products
for value conscious users.
We welcome any comments or suggestions you may have, just call or
write the address below.
We hope you will continue to find us the most complete source for your
tool storage needs.
Model 50230 comes without
swing-out inner panels, and includes
30-piece tool holder set 99852.
Before Assembly of Your Wall Mounted Cabinet
Check carefully to insure that all parts listed on next page are included. If any are missing,
please call 800-413-8665. Do not discard packing material until assembly is complete.
Tools Required
Tape measure and level
Flat tip screwdriver
Drill and drill bit-pilot hole
as required for type of fastener
Kennedy Manufacturing Company • 520 E. Sycamore St. • Van Wert, Ohio 45891
Phone: 800-413-8665 • Fax: 419/238-5644 • www.kennedymfg.com
Assembly Instructions
Style No. 50230 & 50260
TOOL BOXES
CHESTS/CABINETS
WORK STATIONS
®
MODULAR CABINETS
Model 50260 comes with
(2) swing-out inner panels,
and includes 60-piece tool
holder set 99853.
Part No. 527138, Rev. 7/03
page 1 of 2