Nil-Cor 710 Series Installation Instructions Manual

This instruction is intended for use by
persons having technical skill and valve
installation experience,
discretion and risk.
Questions regarding this instruction should
be directed to Nil-Cor Customer Service or
your authorized stocking distributor.
distributor list can be found on the Internet
at: www.nilcor.com.
Initial Inspection
1. Do not remove protective covers until just prior to the
valve installation. If covers are removed for
inspection, they should be replaced immediately
afterward. This precaution is to protect the sealing
faces from damage during storage and handling
operations.
2. Match the serial number on valve nameplate with the
serial number on the enclosed warranty card. If the
numbers match, please complete the warranty card
4855 Broadmoor Ave.  Kentwood, MI 49512  Phone: (616) 554-3100  Fax: (616) 554-5623 
3/10/2016
at their own
A
Nil-Cor. LLC
1
Series 710 UHMWPE
Lined Butterfly Valves
Installation Instructions
Nil-Cor Reserves The Right To Change Product
And Performance Specifications Without Notice
Nil-Cor UHMWPE-Lined Composite Butterfly
Valves offer superior shutoff performance in
a wide range of corrosive and erosive media
and unmatched protection from external
corrosion. At less than half the weight of
lined iron valves, they are less costly to
transport, install
installation instruction will help you obtain
the full benefit of the world's best-performing
lined butterfly valves.
and mail back to Nil-Cor If the numbers do not
match, contact Nil-Cor Customer Service.
3. Check the valve nameplate before installation to
ensure that the pressure rating and materials of
construction are compatible with the intended
service conditions.
4. Inspect adjoining pipelines and remove any material
that could damage the valve liner during installation.
Nil-Cor Recommends
Installation with Task-

Line Gaskets. See
Page 2 for details..

Task-Line gaskets are
available from your Nil-
Cor Distributor.
and support. This
www.nilcor.com