Fig.3 Wheel System, Moving System - Igloo LUZON DEEP Instruction Manual

Hide thumbs

Table of Contents

Available languages

•

Put the connector plug directly into the plug-in socket (it is forbidden to connect the device by extension

cables or splitters!)

Mount display shelves or fi sh tanks, hanging them on aluminium angle sections Fig.5/4;5 (p.19)

Mount glass sides Fig.6/2;1 (p.20)

NOTE: In case of "Gastro" display cabinets, it is necessary to pull out the universal salad tank before

mounting the glass side Fig.5 (p.19), in order to obtain free access to ABS side and to enable easy

glass side with the help of glass holding downs Fig.6/1 (p.20).

Mount the aluminium lamp (together with lighting) on glass sides Fig.6/3 (p.20)

Mount the casing of lamp conduit Fig.6/10 (p.20)

Move the casing of lamp conduit to the back of the glass side, in order to hide the conduit coming out of the lamp

in the casing and to place it on the internal part of the glass side! (This concerns only "GASTRO" display cabinet)

Place universal salad tank in the display cabinet. Place cross-barsunder GN containers in module tank, and then

place GN containers according to Fig.2 (p.17)

Mount front screen Fig.6/8 (p.20)

Mount front glasses of the display cabinet Fig.6/5 (p.20)

Mount night screens Fig.7/1; 2 (p.20)

Place the condensate container on the basis of the device according to Fig.8/3 (p.20) or Fig.9/3 (p.22)

•

The first cleaning of the device should be provide right after unpacking, and before turning it on. The unit should be

cleaned with water at a temperature not exceeding 40°C with a neutral detergent. For washing and cleaning the

equipment it is prohibited to use products containing chlorine and sodium varieties, which destroy the protective

layer and components of the device! Any residue of adhesives or silicone on metal elements should be removed

only with extraction naphtha (not applicable to items made of plastic !). Do not use other organic solvents.

When cleaning the unit is prohibited to use water jet. The unit should be cleaned with a wet rag.

After installation of the device at the destination place it should be left to rest for at least 2 hours before

turning it on (for devices with built in compressor) to set the level of refrigerant in order to prevent pro-

blems with starting up the aggregate.

WARNING: Keep out the cooling circuit from damage!

•

Place the plug of the connecting cable directly in plug-in socket (it is forbidden to connect the device by means of

extension cords or dividers!)

Power sockets (optional) may be used to power cash register, weight, and similar receivers with power not

exceeding 500W!

•

Turn on the main switch Fig.10/1 (p.8), which activates the temperature regulator, and then aggregate of the device

NOTE: If the thermostat display (for „Igloo" thermostat) Fig.6/3 (p.15) only shows two dots at the bot-

tom instead of the temperature, this means that no unit is attached (cooling function disabled). In this

case, switch the cooling on/off button on the thermostat panel - see Fig.11/1 (p.19)!

User manual Luzon, Luzon Deep