Jung 2041 Operating Instructions

KNX
825 234 03
Stand: Jul-08
Operating Instructions
Info-Display

1. General system information

This device is a product of the KNX system and complies with KNX
directives. Detailed technical knowledge obtained in KNX training courses
is a prerequisite to proper understanding. The functionality of this device
depends on the software. Detailed information on loadable software and
attainable functionality as well as the software itself can be obtained from
the manufacturer's product database. Planning, installation and
commissioning of the unit is effected by means of KNX-certified software.
The full functionality with KNX commissioning software from version
ETS3.0d. onwards. The product database, technical descriptions and
conversion programs and other utilities are available in the Internet at
www.jung.de

2. Function

The Info-Display transmits and receives telegrams via the KNX/EIB and
can be used to display (on an LCD display) freely programmable texts
and parameters.
For programming, up to 12 pages with 1, 2 or 4 lines are available.
Each line can be made to represent a function (switching, dimming,
displaying of parameters, etc.).
A additional warning page permits handling of up to 12 alarm messages.
An alarm message can be combined with an acoustic and or optical
warning.
Programming of the device requires the ETS 2 software, version 1.2 and
higher.

3. Safety instructions

Attention: Electrical equipment must be installed and fitted by
qualified electricians only.
Non-observance of the installation instructions may damage the
device and cause fire or other hazards.
Info-Display
Ref.-no.: ..2041..