Related Manuals for AMobile GT78-V
Summary of Contents for AMobile GT78-V
- Page 1 GT78-V 7.85” Rugged Android™ Handheld Device Quick Start Guide Version 1.0 2018.08.
-
Page 2: About This Manual
If you are not sure about any description in this manual, consult your vendor before further handling. We recommend that you keep one copy of this manual for the quick reference for any necessary maintenance in the future. Thank you for choosing AMobile products - 2 -... -
Page 3: General Cleaning Tips
General Cleaning Tips You may need the following precautions before you begin to clean the device. When you clean any single part or component for the device, please thoroughly read and understand the details below. 1. We strongly recommended that you should shut down the system before you start to clean any single components. -
Page 4: Package Contents
Package Contents Upon opening the package, carefully inspect the contents. If any of the items is missing or appears damaged, contact your local dealer or distributor. The package should contain the following items: 7.85” Rugged Android™ Handheld Device Rechargeable Li-ion Battery Pack (Pre-installed) USB Cable Quick Start Guide - 4 -... -
Page 5: Parts Of The Device
Parts of the Device Power button Scan key 10 Speaker Barcode scanner 11 Battery Pogo pin 12 Camera Flashlight USB connector Front Camera 13 Rear Camera Light sensor 14 NFC Touch panel 15 Volume key Microphone 16 SD card slot - 5 -... -
Page 6: Installing Microsd And Sim Card
Installing microSD and SIM Card To install the microSD card and/or SIM card: Installing microSD card 1. Screw off and remove the cover. 2. Follow the direction of 3. Open the lid and insert 4. Close the lid and follow red arrow to open the lid of the mSD card into the the direction to lock. -
Page 7: Charging The Battery
Charging the Battery To charge the battery using an electrical outlet: Using the USB cable that comes with the device, connect the small end of the cable to the USB port on the device. Then connect the other end of the USB cable to the power adapter. Connect the power adapter to an electrical outlet. - Page 8 Protective lid 3. The battery is in a compartment inside. Its opening is covered by a protective lid. Insert the tip of your finger onto the top of the cover and remove it. 4. Then you can remove the battery from the chamber.
-
Page 9: Installing Battery
Installing Battery Contact pins 1. Toinstall the battery, orient the 2. Slide the battery into the battery so that the contact pins battery chamber. faces towards the compartment opening. 3. To restore the protective lid, 4. Align the top edge of the lid make sure the lid is oriented as with the top of the opening. - Page 10 Enabling Wi-Fi and Connecting to a WLAN To set up a WLAN network 1. Swipe down the Status bar and tap the WI-FI tile to enable Wi-Fi if it isn't enabled yet. 2. In the Quick Settings panel, tap and hold the WI-FI tile to access the Wi-Fi settings page.