1. Manuals
  2. Brands
  3. Micron Manuals
  4. Controller
  5. TRAXX
  6. User manual

Micron TRAXX User Manual

4-zone alarm controller
Hide thumbs
1
2
3
Table of Contents

Advertisement

Quick Links

Download this manual
Micron Traxx User Manual
CONTENTS:

Pin Numbers [user codes]

The Keypad Beeper

The status lamp

Two-key Panic

Arm the System

Dis-arm the System

Arm the System [in NIGHT NODE]

Using the TRAXX alarm controller.

PIN numbers (user codes)
TRAXX is capable of storing up to six 4 digit PIN numbers. Each of these numbers may be 1 to
4 digits in length and each may be used to arm or disarm the system.
The keypad beeper.
TRAXX annunciates conditions through the keypad beeper. During an arming cycle the beeper
will sound for the entire exit time. This is a 'leave now' warning. On entry, the beeper sounds for
the programmed entry period. TRAXX will alarm at the expiry of this period. If a valid code is
entered to disarm the system, the beeper emits two short tones. An incorrect entry Is annunciated
as one long tone.
The status (yellow) lamp.
The yellow status lamp is used to indicate several conditions:
Yellow lamp on - the system is arming or armed.
Yellow lamp off - the system is disarmed.
Yellow lamp flashing - an alarm has occured. a system fault exists. the panic facility has been
activated.
Two-key Panic.
If this function has been programmed into TRAXX it may be activated by pressing * and #
simultaneously. A panic activation may be cancelled by entering any valid user code.
To arm the system press:
1 then # (this is a technician selectable option. Ask your installation technician to advise you.)
Alternatively press:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRAXX and is the answer not in the manual?

Questions and answers

Related Manuals for Micron TRAXX

Summary of Contents for Micron TRAXX

  • Page 1 Using the TRAXX alarm controller. PIN numbers (user codes) TRAXX is capable of storing up to six 4 digit PIN numbers. Each of these numbers may be 1 to 4 digits in length and each may be used to arm or disarm the system.
  • Page 2 4+ 6 keys together, then # then old user code then # then new user code then # TRAXX beeps twice each time you enter a valid number. At the end of the above sequence, the old user code is exchanged for the new user code, The new user code may be longer or shorter than the old user code with a maximum of four digits.
  • Page 3 7 then # (two beeps) Each time a sensor is activated while the system is disarmed and CHIME MODE is turned on, the keypad beeps approx. 5 times. In this mode TRAXX acts as a door or area minder while you are at home.

Table of Contents