Bissell CROSSWAVE PET 2225F SERIES User Manual page 11

Empty Dirty Water Tank
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
1
To release Dirty Water
Tank, press down on
recessed button on the
top of the tank.
Did You Know?
The Float Stack is what prevents your Dirty Water Tank from overflowing. When
your Dirty Tank is full, the Float Stack will shut off your suction motor creating a
high pitched sound indicating it is time to empty your Dirty Water Tank.
4
Remove Strainer from Dirty
Water Tank then throw debris
in trash.
7
Hand wash the Vacuum Filter and Screen with
warm water and mild detergent.
2
Grab the front handle while
pressing down on button and
pull Dirty Water Tank away
from the unit.
5
Pour dirty water out. Rinse the
inside of the Dirty Water Tank.
8
Rinse the Float Stack located at the bottom
of the top of the Dirty Water Tank.
3
Grasp top of Dirty Water Tank
in recessed areas on each side
of the filter and pull upward to
remove the top of the tank.
6
Remove the Vacuum Filter and
Screen from the top of the Dirty
Water Tank by pulling it up.
www.BISSELL.com
11