Red Dragon VT 3-30 C Operating Instructions And Parts Manual

Propane torch kits
Table of Contents

Advertisement

Available languages

Available languages

PROPANE TORCH KITS
Operating Instructions and Parts Manual For Models:
DO NOT OPERATE THIS EQUIPMENT IF:
• You are subject to seizures, loss of
consciousness, or fainting.
• You have been drinking alcohol, using
illicit drugs, or prescription drugs that
might effect your judgment or balance.
• You have not read or do not
understand the operator's manual.
• You are not capable of safely
operating this type of equipment.
DO NOT ALLOW CHILDREN TO
OPERATE THIS EQUIPMENT.
Model
VT 3-30 C
500,000
VT 2
1
/
-30 C
400,000
2
1
VT 2
/
-24 CE
500,000
2
BP 2512 C
400,000
VT 3-30 SVC
500,000
VT 2
1
/
-30 SVC 400,000
2
1
VT 2
/
-24 SVC 500,000
2
BP 2512 SVC
400,000
IMPORTANT WARNINGS:
PO Box 577 • 230 W. Hwy 4
LaCrosse, Kansas 67548
785-222-2873 • FAX 785-222-3619
Toll Free 800-255-2469
www.FlameEngineering.com
Please Read and Follow
All Instructions and
Save These Instructions
For Future Reference.
®
vapor-withdrawal LP-Gas cylinder only.
BTU
P.S.I.
5-90 P.S.I.
5-90 P.S.I.
5-90 P.S.I.
5-90 P.S.I.
5-90 P.S.I.
5-90 P.S.I.
5-90 P.S.I.
5-90 P.S.I.
FOR YOUR SAFETY!
If You Smell Gas:
1. Shut off gas to the device.
2. Extinguish any open flame.
3. Check the device for leaks using
soapy water.
4. DO NOT attempt to relight the
device until leaks are repaired and
there is no gas smell
DO NOT use this device in areas
where gasoline or other liquids having
flammable vapor are stored or used.
• This device is intended
for outdoor use only.
• This torch is designed for a
Normal
30 P.S.I.
25 P.S.I.
30 P.S.I.
25 P.S.I.
30 P.S.I.
25 P.S.I.
30 P.S.I.
25 P.S.I.
EPA Est. 092521-KS-1
VT-MAN-10-2016

Advertisement

Table of Contents
loading

Summary of Contents for Red Dragon VT 3-30 C

  • Page 1 ® • This torch is designed for a PROPANE TORCH KITS vapor-withdrawal LP-Gas cylinder only. Operating Instructions and Parts Manual For Models: Model P.S.I. Normal VT 3-30 C 500,000 5-90 P.S.I. 30 P.S.I. VT 2 -30 C 400,000 5-90 P.S.I.
  • Page 2 5. Using thread compound, connect the female end of the hose to the 1/4” male end of the P-3200W P.O.L. Tighten securely. Parts List Diagram for Models: • VT 3-30 C • VT 2 -30 C • VT 2 -24 CE Flame Adjusting Needle Valve...
  • Page 3 Red Dragon Back Pack Tank Mounting Instructions For Models: • BP2512C • BP2512SVC Top Tank 1. Place Bottom Tank Ring onto Bottom 1/2” x 1” Bolt Mounting Bracket Tank Mounting Bracket. 2. Line up one of the large holes on the 1/2”...
  • Page 4: Safety Checklist

    Do not use damaged cylinder. Know if you are using liquid or vapor with- drawal. USE ONLY VAPOR WITHDRAWAL CYLINDER WITH THE VT 3-30 C, VT 2 -30 C, VT 2 -24 CE, BP 2512 SVC, VT 3-30 SVC,...
  • Page 5: Important Note

    • Never direct torch flame toward any person, animal, flamable surface or material. Important Note: All Red Dragon torch kits are equipped with an excess flow ®...
  • Page 6 be readily apparent and could result in property damage and injury to persons. When working in these locations, keep the torch moving in a back-and-forth motion. Lingering or pausing in one spot could ignite the panel or the material behind it. E.
  • Page 7: Lighting Instructions

    NOT SWEEP, DRY DUST OR VACUUM. Use a high phosphate detergent or trisodium phosphate (TSP) to wash and mop areas. 10. At the end of each work session put the paint chips and debris in a double plastic bag, close it with tape or twist ties and dispose of properly. 11.
  • Page 8: Maintenance

    NOT PLACE YOUR HAND OR ANY PART OF YOUR BODY IN THE PATH OF THE BURNER WHILE LIGHTING OR OPERATING THE TORCH. DO NOT USE MATCHES OR CIGARETTE LIGHTER TO IGNITE THE TORCH. 4. Adjust the size of the pilot flame by using the flame adjusting valve. Adjust to a low flame that will keep the torch burning in existing conditions, a small flame is usually adequate.
  • Page 9 For More Information: Consult your local LP Dealer, Flame Engineering, NPGA, or NFPA Pamphlet 58. This information is provided as a general guide for safe LP-Gas use and in no way constitutes a complete safety program. Troubleshooting Your Torch Kit Operation: For more info go to www.flameengineering.com I have only a weak/wimpy flame? You are probably turning on your propane tank and torch kit too quickly.
  • Page 10 Flame Weeding 101: How to correctly flame your weeds. When flame weeding, the most effective method is to catch weeds early, from 1-4 inches. At this small stage, flaming is nearly 100% effective, whereas weeds over 4 inches are more difficult to kill without and extended dose of heat. You only want to heat the leaves of the weed in need of removal.
  • Page 11 AU PROPANE pétrole liquéfié à extraction de vapeur. Instructions d’utilisation et manuel des pièces pour les modèles : Model P.S.I. Normal VT 3-30 C 500,000 5-90 P.S.I. 30 P.S.I. VT 2 -30 C 400,000 5-90 P.S.I.
  • Page 12: Instructions D'assemblage

    à l’extrémité mâle de 1/4 po du P-3200W P.O.L. Serrez-la fermement. Schéma de liste de pièces pour modèles • VT 3-30 C • VT 2 -30 C • VT 2 -24 CE Vanne aiguille d’ajustement de la flamme Chalumeau à...
  • Page 13 Instructions de montage de réservoir sac à dos Red Dragon Pour les modèles: • BP2512C • BP2512SVC Écrou de 1/2 po x 1 po Support de montage 1. Placez l’anneau inférieur du réservoir inférieur du réservoir sur le support de montage inférieur du réservoir.
  • Page 14 Liste de vérification de sécurité: • On doit porter des gants en tout temps. Il est recommandé de porter des manches longues, des pantalons et des bottes. • Utilisez uniquement les chalumeaux à vapeur sur des bouteilles équipées de vannes d’extraction de vapeur. •...
  • Page 15: Remarque Importante

    ATTENTION • Le propane est plus lourd que l’air, ce qui peut faire en sorte qu’il s’accumule dans les zones plus basses. Assurez-vous que toutes les zones sont bien ventilées. • Le propane a une ODEUR distincte. Si vous la sentez, arrêtez IMMÉDIATEMENT le travail, éteignez toutes les flammes, localisez la fuite et éliminez-la, et ventilez la zone avant d’allumer le chalumeau.
  • Page 16 l’utilisation du pistolet thermique dans ces endroits. L’inflammation de ces matériaux pourrait ne pas être évidente et pourrait mener à des dommages matériels ainsi qu’à des blessures. Lorsque vous travaillez dans ces endroits, déplacez continuellement le chalumeau vers l’avant et l’arrière. S’arrêter ou rester trop longtemps à...
  • Page 17: Instructions D'allumage

    N’UTILISEZ PAS DE BALAI, DE PLUMEAU OU D’ASPIRATEUR. Utilisez un détergent à forte teneur en phosphate ou du phosphate trisodique (PTS) pour laver les zones et y passer la vadrouille. 10. Après chaque séance de travail, mettez les écailles de peinture et les débris dans un sac de plastique doublé, fermez-le avec du ruban adhésif ou des attaches de sacs à...
  • Page 18: Entretien

    LE CHALUMEAU. N’UTILISEZ PAS D’ALLUMETTES OU DE BRIQUET À CIGARETTE POUR ALLUMER LE CHALUMEAU. 4. Ajustez la taille de la flamme pilote en utilisant la vanne d’ajustement de la flamme. Faites des ajustements pour obtenir une flamme faible qui gardera le chalumeau allumé dans les conditions actuelles;...
  • Page 19: Pour Plus D'information

    Pour plus d’information: Consultez votre détaillant de propane liquéfié local, Flame Engineering, la NPGA (Association nationale du propane gazeux) ou la brochure 58 de la NFPA (Association nationale de prévention des incendies). Cette information est fournie en tant que guide général pour l’utilisation sécuritaire des gaz de pétrole liquéfié...
  • Page 20 Cours de base sur le désherbage thermique: Comment éliminer correctement les mauvaises herbes avec une flamme. L’efficacité du désherbage thermique sera maximisée si on l’effectue lorsque les mauvaises herbes sont encore petites, de 3 à 10 cm (1 à 4 po). Lors de ce stade précoce, le désherbage thermique atteint presque 100 % d’efficacité, tandis que les herbes mesurant plus de 10 cm (4 po) sont plus difficiles à...
  • Page 21 EQUIPOS DE SOPLETE cilindro de gas LP de recuperación del DE PROPANO vapor únicamente. Operating Instructions and Parts Manual For Models: Modelo P.S.I. Normal VT 3-30 C 500,000 5-90 P.S.I. 30 P.S.I. VT 2 -30 C 400,000 5-90 P.S.I. 25 P.S.I.
  • Page 22: Instrucciones De Armado

    1/4” del P-3200W P.O.L. Apriete con firmeza. end of the P-3200W P.O.L. Tighten securely. Diagrama de la lista de partes para los modelos: • VT 3-30 C • VT 2 -30 C • VT 2 -24 CE Válvula de aguja de ajuste Flame...
  • Page 23 Instrucciones de montaje del tanque de mochila Red Dragon para modelos: • BP2512C • BP2512SVC Soporte superior del 1. Coloque el anillo inferior del tanque en el Perno de 1/2” x 1” montaje del tanque soporte inferior del montaje del tanque.
  • Page 24 No utilice un cilindro dañado. Sepa si está usando recuperación de líquido o de vapor. USE SOLO CILINDRO DE RECUPERACIÓN DE VAPOR CON LOS EQUIPOS DE SOPLETES VT 3-30 C, VT 21/2-30 C, VT 21/2-24 CE, BP 2512 SVC, VT 3-30 SVC, VT 21/2-30 SVC, VT 21/2-24 SVC Y BP 2512 SVC.
  • Page 25: Nota Importante

    • Nunca apunte la flama del soplete a una persona, animal, o superficie o material inflamable. Nota importante: Todos los equipos de soplete Red Dragon están equipados con un dispositivo de seguridad ® limitador de flujo excesivo ubicado en el POL de limitador de flujo excesivo de punta suave...
  • Page 26 Al trabajar en estos lugares, mantenga el soplete con movimientos de ida y vuelta. Quedarse inmóvil o pausar en un lugar puede encender el panel o el material detrás de él. E. No use este soplete para retirar la pintura (si el soplete puede usarse para retirar pintura, deberán seguirse los puntos (F) y (G) abajo.
  • Page 27: Instrucciones De Iluminación

    10. Al final de cada sesión de trabajo, ponga las virutas y restos de pintura en una bolsa doble de plástico, ciérrela con cinta o alambre y deséchela correctamente. 11. Retire la ropa protectora y calzado de trabajo en el área de trabajo para evitar llevar el polvo al resto de la vivienda.
  • Page 28: Mantenimiento

    QUEMADOR MIENTRAS ENCIENDE U OPERA EL SOPLETE. NO USE CERILLOS NI UN ENCENDEDOR DE CIGARRILLOS PARA ENCENDER EL SOPLETE. 4. Ajuste el tamaño de la flama del piloto con la válvula de ajuste de flama. Ajuste a una flama baja que mantendrá...
  • Page 29 Para mayor información: Consulte a su distribuidor de LP local, Flame Engineering, panfleto 58 de NPGA o NFPA. Esta información se provee como guía general para tener un uso de gas LP seguro y de ninguna manera representa un programa de seguridad completo. Resolución de problemas en la operación de su equipo de soplete: Para mayor información, visite www.flameengineering.com Tengo solamente una flama débil/pequeña.
  • Page 30 Desherbar con fuego 101: Cómo quemar sus hierbas correctamente. Cuando deshierbe con fuego, el método más eficaz es hacerlo anticipadamente cuando midan de 1 a 4 pulgadas. En esta etapa temprana, el fuego es casi 100 % eficaz, mientras que las hierbas mayores a 4 pulgadas son más difíciles de eliminar sin una dosis extendida de calor.

Table of Contents