HPM EF200SQ Instruction Sheet

EF200RD and EF250RD
1 Installation
1. Determine position in ceiling
where the Exhaust Fan is
required to be installed. (Do not
install within 120cm of stove or
inside a shower recess).
Be certain that the installation
area is not restricted by roof
beams above ceiling.
5. Remove grille and insert unit
into hole.
200mm models: Cat. EF200RDWE, EF200SQWE, EF200RDMS
250mm models: EF250RDWE, EF250SQWE, EF250RDMS
EF200SQ and EF250SQ
2. Use template provided to draw
a circle – Cat EF200: 242mm,
Cat EF250: 298mm.
To do this insert a thumb tack
in hole at one end and insert
a pencil in the other hole and
scribe a circle.
6. Tighten the screws until the
sliding clamps securely grip the
ceiling material.
Ceiling Exhaust Fan
200mm and 250mm
3. Use electric jig saw or small
hand saw to cut out around this
line. Several holes drilled at a
point inside the circle provides
a convenient starting point for
cutting the panel out.
7. It is recommended that the
three sliding clamps be checked
for the correct clamping by
inspection from above.
Instruction Sheet
4. The Exhaust Fan is supplied
with lead and 2 pin plug.
Ensure that a power outlet is
installed near the fan. (This
outlet may be controlled by a
standard switch or time delay
switch.) Check power to the
outlet is off. Plug the fan into
this power outlet.
8. Push grille into unit and click
into position.