Table of Contents
Advertisement
Installation / Assembly Instructions
Cascade Wide Tub
1-866-PENNERS
TUBS- 360010-1, 360010-1L, 360010-1W, 360010-X, 360010-XL, and 360010-XW,
361910-1, 361910-X, 362010-1, 362010-1L, 362010-X, 362010-XL,
RESERVOIRS- 370000-1W, 370000-1WL, 370000-XW, 370000-XWL
E-mail Address: pennersales@hamilton.net
Web Site: www.pennerpatientcare.com
Aqua-Aire
Sit-Bath System 6900
Standard / Wide / End Opening
PENNER PATIENT CARE, INC
Box 523 / 102 Grant St.
Aurora, NE 68818
360745 Revision F – 02/04/08
1-866-736-6377
Cascade End Opening Tub
1-800-732-0717
Advertisement
Table of Contents
Related Manuals for Penner Manufacturing Cascade Aqua-Aire
Summary of Contents for Penner Manufacturing Cascade Aqua-Aire
- Page 1 Aqua-Aire Sit-Bath System 6900 Standard / Wide / End Opening Installation / Assembly Instructions Cascade Wide Tub Cascade End Opening Tub PENNER PATIENT CARE, INC Box 523 / 102 Grant St. Aurora, NE 68818 360745 Revision F – 02/04/08 1-866-PENNERS 1-866-736-6377 1-800-732-0717 TUBS- 360010-1, 360010-1L, 360010-1W, 360010-X, 360010-XL, and 360010-XW,...
-
Page 2: Table Of Contents
Table of Contents TABLE OF CONTENTS ......................2 INTRODUCTION: ........................3 TERMINOLOGY AND SYMBOLS MEANINGS: ..............3 BASIC ROOM DIMENSIONS: ....................3 DRAIN REQUIREMENTS: ......................6 HOT AND COLD WATER SUPPLY REQUIREMENTS:............7 ELECTRICAL REQUIREMENTS: ....................7 UNPACKING THE TUB: ......................7 UNPACKING THE RESERVOIR: .....................8 TUB MODIFICATIONS FOR RESERVOIR: ................8 ASSEMBLING THE RESERVOIR: ...................8 WATER SUPPLY HOSE CONNECTIONS: ................9 ANCHORING THE TUB/RESERVOIR: ...................9... -
Page 3: Introduction
Introduction: These instructions are for the installation of a Cascade Sit-Bath System 6900 Tub, Standard or Wide, with or without a Cascade Reservoir. The Reservoir is an optional accessory, which is to be pre-filled prior to placing the resident into the tub. Then the water in the reservoir can be released into the tub. - Page 4 Figure 3 Room layout for Standard Cascade with a Wide Reservoir Figure 4...
- Page 5 Room layout for Wide Cascade with a Wide Reservoir Figure 5 Room layout Side View for Cascade with Wide Reservoir Figure 6 Room Layout Side View for End Opening Cascade...
-
Page 6: Drain Requirements
Figure 7 Room Layout Top View for End Opening Cascade Drain requirements: The tub is equipped with a 2” nominal (2 3/8” O.D.) PVC drain pipe. As shown in Figure 8, the tub’s drain pipe is approximately 11” from the wall and 5 1/4” above the floor. Figure 8 shows two different options for roughing in the drain pipe –... -
Page 7: Hot And Cold Water Supply Requirements
Figure 8 Suggested Rough-ins Hot and cold water supply requirements: 3/4” supply lines with on/off valves with 3/4” NPT female threads. We recommend 3/4” ball valve with 3/4” NPT female ports. (Valves supplied by others.) See figure 8 for recommended locations. For optimum performance, dynamic pressures should be nominally equal between hot and cold supplies. -
Page 8: Unpacking The Reservoir
4. If a Cascade Reservoir is to be installed with the tub, continue with “Unpacking the Reservoir”. If not, skip to “Water Supply Hose Connections”. Unpacking the Reservoir: 1. Remove the Reservoir from the shipping crate. 2. Locate and save the installation parts. 3. -
Page 9: Water Supply Hose Connections
2. Connect the reservoir outlet pipe to the outlet adapter with the provided flex coupling and tighten. Reference Figure 9. 3. Connect the reservoir supply hose, from the reservoir plumbing assembly, to the water line port at the back of the tub. 4. -
Page 10: Electrical Connections
1. Connect the ends of the connecting hoses (hot and cold water supply) to the respective ports on the tub. Ensure that there are sealing gaskets within the swivel fittings on the hoses. 2. Connect the drain (waste) of the tub to the facility’s drain system. 3. -
Page 11: Finishing Up
6. Use the provided female disconnect wire terminal to connect the “line” wire to the circuit breaker tab marked “L”. The provided female disconnect wire terminal is shipped already connected to the circuit breaker. 7. Replace the electrical enclosure cover. With the tubs circuit breaker switch in the “OFF” position, turn “ON”... -
Page 12: Tub And Reservoir Controls
Tub and Reservoir Controls: Figure 11 Tub Controls Disinfect button Rinse button (Aqua-Air tubs only Filling spout Tub fill ON/OFF button Fill / Shower water temperature readout Mixing valve – Temperature control Reservoir Temperature readout * Tub water temperature readout Shower ON button (The unit has a time adjustable automatic shut-off) Hand shower sprayer Aqua-Air ON/OFF button... - Page 13 For your nearest distributor, contact: PENNER PATIENT CARE, INC. Box 523 / 102 Grant St. Aurora, NE 68818 1-866-PENNERS 1-866-736-6377 1-800-732-0717 E-mail Address: pennersales@hamilton.net Web Site: www.pennerpatientcare.com...
Need help?
Do you have a question about the Cascade Aqua-Aire and is the answer not in the manual?
Questions and answers