Table of Contents
Advertisement
Appendix E
The iServer may also be assigned an IP Address by using the iConnect software.
a)
Download the iConnect software from the website listed in this manual.
b)
Install iConnect software on a networked PC. This software is compatible with
Windows 95, 98, NT, 2000, and XP.
c)
Use iConnect to assign an IP address to the iServer and access its web pages
for configuration. You can also use any standard web browser to access the
iServer's web pages. Consult with your IT department for obtaining an IP
address.
Figure E-1 Assigning an IP Address using iConnect
1) Place the IP address in this box.
2) Take the MAC address from the label attached to the bottom of the iServer and
place it in this box.
3) Click here to send the above IP address to the iServer.
4) After the IP address is assigned to the iServer, click here to access it's web
pages.
5) Click here to Ping the iServer whose IP address is shown in the IP address box.
6) Click here to find all the iServer's on your network .
7) The IP addresses for the iServer's found by the iConnect will be listed here.
8) These fields indicate the IP address and the subnet mask of the PC on which
the iConnect is running.
iConnect Software
48
Advertisement
Table of Contents
